COMMUNITY FORUM

shirleypelicanfun

05:41AM | 09/15/05
Member Since: 09/14/05
3 lifetime posts
Bvelectrical
My Kenmore Elite Dryer keeps stopping

model # 110 61086000 Ser.# ML0403277

Type DDOT-ELE2406028EL54

could you tell me what part and how to order it and how to instal it Please.

Shirley J Cherry

DanO

11:10AM | 09/15/05
Member Since: 11/11/02
2274 lifetime posts
** Kenmore Elite Dryer [ model # 110.61086000 ] keeps stopping **

When? After in use a while? Immediately (eg. only runs while holding the start button)??

Do you have to wait a while before it will start back up again or will it start right back up??

Dan O.

www.Appliance411.com/?ref411=Kenmore+Dryer

The Appliance Information Site

=D~~~~~~

shirleypelicanfun

11:24AM | 09/15/05
Member Since: 09/14/05
3 lifetime posts
It starts ok will run any-weres from 2 min. to 5 min. or sometimes (getting fewer) runs till dry. will start back up when ever I see its off even with the error E1 I have to press stop then restart. You never have to hold the button. It starts on any setting...but verys on weather it gives the E1 error. I cant find anysetting that will just run, till dry even the times settings shut down.

Shirley J Cherry

DanO

05:10PM | 09/15/05
Member Since: 11/11/02
2274 lifetime posts
** will start back up when ever I see its off even with the error E1 **

You never stated you were getting any type of error message. That is usually an *important* indicator and would usually be worth mentioning.

An E1 error message usually indicates that the thermistor (see the following link) is defective and needs to be replaced. Without that part working properly, the electronic control could do unexpected things.

- Kenmore 110.61086000 Thermister

LINK > http://www.appliance411.com/data.php?rc=548392

JMO

Dan O.

www.Appliance411.com/?ref411=Kenmore+Dryer

The Appliance Information Site

=D~~~~~~

shirleypelicanfun

05:02AM | 09/16/05
Member Since: 09/14/05
3 lifetime posts
Sorry for not explaining the error message but I have posted on many other sites and cant get a stright answer and I just forgot to tell you that. Ok I want to know How to replace the "thermister" I have the front pannel off the dryer below the door and I do not see that part can you tell me how big it is like half inch or so? And were do I find it? I dont want to order one if I dont know where to put it. The vent guard covers most of my front area but on my right side theres about 12" with two wires leading from top to middle and bottom to middle conected by a white conector with two red plastic disks the size of a dime then behind that is a black tube shape thing leading from front to back with wires conected to it but I cant see them or reach them...where do I find the part I need?

Shirley J Cherry

DanO

09:26AM | 09/16/05
Member Since: 11/11/02
2274 lifetime posts
** I have the front panel off the dryer below the door and I do not see that part can you tell me how big it is like half inch or so? **

There is a gird reference in the picture of the part link I supplied. The grids are 1" square, the part is about 2" by 1".

- Kenmore 110.61086000 Thermister

LINK > http://www.appliance411.com/data.php?rc=548392

** And were do I find it? **

It is on the side of the blower housing. It is item # 42 in the exploded parts view for your model at the following link:

- 110.61086000 Exploded Parts View

LINK > http://tinyurl.com/ds6wn

If interested, the repair manual for Whirlpool built dryers at the following link should cover most common service procedures for your dryer since it was made for S ears by Whirlpool.

- Whirlpool/Kenmore Dryer Repair Manual

LINK > http://www.appliance411.com/data.php?rc=753981

JFYI

Dan O.

www.Appliance411.com/?ref411=Kenmore+Dryer

The Appliance Information Site

=D~~~~~~
Click_to_reply_button
Inspiration_banner

INSPIRATION GALLERY



Post a reply as Anonymous

Photo must be in JPG, GIF or PNG format and less than 5MB.

Reply_choose_button

captcha
type the code from the image

Anonymous

Post_new_button or Login_button
Register

Colorful, useful, and fun, these tire planters form the foundation for a delightful container garden. Just spray-paint old... Reused steel windows create an eye-catching splashguard in this walk-in shower. The vintage factory windows bring an inter... A galvanized steel tub is a surprising but charming fixture in this bright and breezy screened patio. It's perfect for was... If you're not crazy about the idea of commingling plants and pool, this modern variation may be more to your liking. The s... Yes, a freestanding garage can become its own tiny house. Artist Michelle de la Vega has all the comforts of a modern resi... If you lack plumbing skills but have a good sturdy tree, here's the easiest outdoor shower solution of all: Simply attach... Pursue what's known as the stack effect. To achieve it, open the windows on both the upper and lower floors, and as warm a... How do you like this smart use for an old bottle? Clamp an empty wine bottle to a fence or wall near your outdoor deck or ... Simple and striking, a couple of pieces of "lovingly used" furniture creates a special kind of charm. A weathered chair fo... Twine lanterns add pops of crafty—but sophisticated—flair to any outdoor setting. Wrap glue-soaked twine around a balloon ... When securely fastened to a tree or the ceiling of a porch, a pallet and some cushioning make the ideal place to lounge. V... Incorporate nature into your lighting scheme by securing a dead tree in a concrete mold and draping your pendant lamp from... For the cost of a can of exterior paint , you can totally transform your porch. Paint the floor a hue that complements yo... In this urban apartment, a standard-issue patio became a serene and green perch by replacing the typical concrete with gro... This garden shed has been decked out to the nines. Designer Orla Kiely created the intimate home for a flower trade show, ...
Follow_banner_a
Newsletter_icon Google_plus Facebook Twitter Pinterest Youtube Rss_icon
 
webapp1