** kenmore dishwasher model number 110733501 **

I can find no listing for such a model number. Did you get it right off the appliance's model and serial number identification tag?

** sprung a leak... if you have any suggestions **

I would think someone is going to have to investigate to find where exactly on the machine the leak is originating before anyone will be able to suggest how it might be possible to correct it.

JMO

Dan O.

www.Appliance411.com/parts/?ref411=Kenmore+Dsiwasher

The Appliance Information Site

=D~~~~~~

i did get the number off the small silver tag inside the dishwasher, the leak is on the right side of the door, it starts about 5 ins above the floor... huge puddle, but it dosnt start until half hour into the wash. im not sure whats causing it, but any suggestions would be appreceated. thanks

sounds like an older model,

I've seen an Ultra 110.753613 referenced on the manual site.

Might be a leak in the rinse aid dispenser in the door, if you have one.

Anyway, check your dishwasher in the following locations to find the model number (the serial number should be right beneath the full model number on the same plate/sticker):

On Right Hand Side of Upper Front Tub or Door Jam

On Flange Behind Dishwasher Door

Behind Latch Strike

Upper Left Corner of Frame.

Look really close, there should be (VERY MUCH SMALLER POSSIBLY) three numbers before the nine that you picked up between the word model and the numbers you wrote down that start with 110

If you're in Canada, it may or may not have a C prefix in front of the three tiny numbers.

** it starts about 5 ins above the floor **

About 5 inches above the floor is the dishwasehr's whole tub and also the door. Someone is going to have to pinpoint the original much more closely before anyone is likely to be able to suggest a possible cause.

JMO

Dan O.

www.Appliance411.com/parts/?ref411=Kenmore+Dishwasher

The Appliance Information Site

=D~~~~~~

the model # i listed is all that is shown, the serial # is fd2620494 but thats all that is there. it says sears if that helps at all...

leak is about 4cm from right bottom hinge. it looks like there ws a plastic thing in the hinge that isnt there anymore.

Notice you didn't say if you were or were not in Canada. I'm going to take that you are in Canada, since you identified location of the leak using metric measurements.

Suspect its an older inglis (canadian whirlpool) made dishwasher. Likely significantly older.

Suggest you call Inglis/whirlpool canada at 1-800-461-5681 toll free from canada to request a user's manual and parts manual be sent to you. They can help identify the exact model and its vintage with their database which is more extensive (and proprietary).

Their Customer Interaction Centre may be able to talk you through a remedy.

thanks ill give that number a try.. and yes the metric thing means im in canada :P thanks for your help, its greatly appreceated