This washer fills, agitates, drains, but doesn't spin. I hear the motor running if I didn't have the lid open amd the door switch ingaged an looking at the tub not sinning I would think it was sinning from the sounds it is making with timer on spin.
I have heard and read a lot about the coupler is broken if the washer doesn't spin, but I would think none of the motor driven functions would work eather.
I can run a full load of cloths and it works fine till the spin cycle and no spin.
Can anyone throw me a life line in some suggestions why no spin. Tims are hard and I have to fix this cause a repairman or replacement washer isn't in the budget right now.
I would greatly appreciate your helping sugestion as to is it electrical or the mecanical transmition box.
Tks, rotton1
COMMUNITY FORUM
- Forum >
- Electrical & Lighting >
- Kenmore 90 series Modle 110.20922990
** I have heard and read a lot about the coupler is broken if the washer doesn't spin, but I would think none of the motor driven functions would work eather. **
If the coupler was broken the washer would not spin OR agitate. It would still drain.
** This washer fills, agitates, drains, but doesn't spin. I hear the motor running **
There are 3 possibilities I can think of.
1. The timer is not pausing between drain and spin (see the following link).
- Timer Pause
LINK > www.the-appliance-clinic.com/ddtimer-pause.html
2. There is a problem with the 'neutral drain' mechanism inside the transmission. It is a common failure point and would require either the whole transmission to be replaced or it opened up and the affected parts replaced which come together in a 'kit' with instructions.
- Transmission/Gearcase Complete
LINK > www.appliance411.com/data.php?rcpn=3360629
- Transmission Neutral Drain Repair Kit
LINK > www.appliance411.com/data.php?rc=2911
3. The clutch may be worn or contaminated with water or oil and totally slipping. This is the least likely cause IMO.
JMO
Dan O.
www.Appliance411.com/parts/?ref411=Kenmore+Washer
The Appliance Information Site
=D~~~~~~
If the coupler was broken the washer would not spin OR agitate. It would still drain.
** This washer fills, agitates, drains, but doesn't spin. I hear the motor running **
There are 3 possibilities I can think of.
1. The timer is not pausing between drain and spin (see the following link).
- Timer Pause
LINK > www.the-appliance-clinic.com/ddtimer-pause.html
2. There is a problem with the 'neutral drain' mechanism inside the transmission. It is a common failure point and would require either the whole transmission to be replaced or it opened up and the affected parts replaced which come together in a 'kit' with instructions.
- Transmission/Gearcase Complete
LINK > www.appliance411.com/data.php?rcpn=3360629
- Transmission Neutral Drain Repair Kit
LINK > www.appliance411.com/data.php?rc=2911
3. The clutch may be worn or contaminated with water or oil and totally slipping. This is the least likely cause IMO.
JMO
Dan O.
www.Appliance411.com/parts/?ref411=Kenmore+Washer
The Appliance Information Site
=D~~~~~~
