I decided to upgrade my kitchen faucet for no particular reason, along with my sink, garabge disposal and hoses. I purchased two brand new faucets and they both dripped from the spout afer I installed them. First I tried a ball type faucet and then a cartidge type. Both had a slow drip from the spout. I was thinking about maybe putting some silicon grease around the washer that is in the spout (the rubber washer that is on the screen). Any suggestions? Thanks
Bigdude
COMMUNITY FORUM
Dear Mr. Bigdude,
I have said this before I will say it again, if you can truly say that you have not disassembled these faucets. Take them back and exchange them for ones that work properly and correctly.
I am sorry you have to go through the hassle but you are the consumer and you should demand and expect perfection for your hard earned money. If you purchased them from a big box retailer, I would start screaming at the Manager or Dept head for some compensation and start voicing your displeasure.
Sincerely,
Jim
I have said this before I will say it again, if you can truly say that you have not disassembled these faucets. Take them back and exchange them for ones that work properly and correctly.
I am sorry you have to go through the hassle but you are the consumer and you should demand and expect perfection for your hard earned money. If you purchased them from a big box retailer, I would start screaming at the Manager or Dept head for some compensation and start voicing your displeasure.
Sincerely,
Jim
