I was wondering, I noticed in the instructions for my thermostat that there is a way to connect seperate heat and coll transformers to the stat, but how would you connect seperate blower units? Would you parallel the G & W wires to each unit, but power off the one your not using at the time?
Well the idea would be to run the AC seperate from the furnace. Right now the old AC/furnace is blocked off and shut down and the new furnace is connected. In the summer I would like to reverse that and block off and shut down the new furnace and run the old AC instead.
If you are using one unit for heat and one for ac, Remove the jumper between rc and rh and wire as if it were two seperate transformers, which it is.
best of luck
best of luck
That part I figured out, but what about the blower, which would be the W & G wires for the old furnace?
the g terminal and thegreen wire are always fan. This must run from the ac unit. The w terminal and white wire are always heat they will go to the furnace. There must be a yellow wire that gets put to the y terminal and wired to the ac unit
- 15 Old House Features We Shouldn't Abandon
- 17 Tiny Bathrooms We Love
- 16 Designs for a Low-Cost DIY Coffee Table
- Insanely Easy 60-Minute Home Improvements
- 12 Sheds You Could Live (or Work) In
- Assembly Required: 15 DIY Kit Homes
- 30 Things Every Adult Should Know How to Do
- 10 Surprisingly Simple Woodworking Projects
- 7 Surprising Other Uses for Mayonnaise
- 9 Ways to Make Your TV Look at Home
- 9 Totally Amazing Mobile Home Makeovers
- 8 Cleaning Mistakes Everyone Makes
- 10 Insanely Creative Shelves You Can DIY
- 10 Bargain Organizers for a Tidy Garage
- 7 Easy Budget-Friendly Backyard Makeovers
- 9 Backyard Fire Pits You Can Afford
- 10 Things You Didn't Know Windex Can Do
- Watch These 10 Home Trends Take Off in 2015
- Surprisingly Simple Woodworking Projects
- 16 Garden Borders You Can Make—Easily!