COMMUNITY FORUM

I have dual blowers on my gas fired shop heater. I would blow one leg fuse of the power. The belt would squeek on initial start up. I changed the belt and it and the squek is gone. The belt has proper tension on it/. But it is loud or bangs when the fan motor starts. If I take the belt off, the motor is whisper quiet. Could I have bad bearings on the blowers? When I spin them by hand, they spin freely. I am going to drop back and

I just had a tech clean the air tubes going across the gas burners but loud boom stopped and has now returned.Lasted about a week..also the tech showed me a rather large hole in the firewall of the gas furnace.I have an American Standard GPH Hydronic Gas Furnace GPH 100.Any Ideas why the problem keeps happening?Oh,and I also noticed a crack and a small hole just above the exhaust pipe going into the chimney,could this be part of the cause? Anybody know? Thanks!

if this bang noise is air intake, that is one thing, but thebank is a crack in the wall, wouldn't your carbon detector being going off!? both could be bad! just wondering, I have a 25yr old gas furnace in a mobile home

sorry for the type~o

if this bang noise is air intake, that is one thing, but the bang is a crack in the wall, wouldn't your carbon detector being going off!? both could be bad! just wondering, I have a 25yr old gas furnace in a mobile home

Mine does it to and scares the s!;t out of me it is freaky it makess me think someone is in my house it makes the floors creak like someone is walking around in my house I hate it and I have had two gas leaks before I hope there is no gas leak.