I am trying to install 1/4 rnd trim on the sides of the stairs after laying carpet ... what angle cut is this with the miter???
Thanks!
COMMUNITY FORUM
- Forum >
- Tools & Workshop >
- Cutting 1/4 rnd trim
How Do I Fix My Table Saw I Have 10" Delta Table Saw, The Motor Runs But The Blade Does Not Spin.
We were cutting through a board and it was spinning and cutting just fine but then stopped. The board wasn't knotty - it was a thick piece of oak trim. When we turn it on the motor will run but the blade won't spin. Although it did start to just spin a bit at one point but then stopped. What could be going on?
We were cutting through a board and it was spinning and cutting just fine but then stopped. The board wasn't knotty - it was a thick piece of oak trim. When we turn it on the motor will run but the blade won't spin. Although it did start to just spin a bit at one point but then stopped. What could be going on?
