pavers
I sounds as if you may have applied the product to heavy as alot of these water based products go on milky and dry clear. It may go away with time ...
COMMUNITY FORUM
Recent Posts
over 5 years by 5slb6
18
answers707
Views
skimming
Yes you can apply drywall mud with a roller. You can thin it with water or even mix flat latex paint into it. I would experiment on some scrap wall...
over 5 years by 5slb6
12
answers159
Views
elastomeric
It is no different than with any other exterior acrylic coating. It will need to be washed every so often to remove dirt and mildew and this can be...
over 5 years by 5slb6
1
answers223
Views
skimming
It is putting a thin coat of drywall mud over the surface of the wall with a wide broadknife.
over 5 years by 5slb6
12
answers776
Views
pavers milky
Is this a waterbased or oil based product?
over 5 years by 5slb6
18
answers984
Views
SHELF
The problem you have is the rusting of the metal and if you just put a clear product on the metal it may still rust, and then you would have a very...
over 5 years by 5slb6
3
answers313
Views
shelf
Is this galvanized or regular steel? You can check with the fabricator to be sure.
over 5 years by 5slb6
3
answers604
Views
sprayer
I will try and help as I sold spray equipment for 30 years. A spray machine is rated in gallons a minute and gallons planed on being used. The ...
over 5 years by 5slb6
1
answers765
Views
popcorn
You need to go to a local paint store and get some names of contractors from them. They have a good idea of who does good work as often times they ...
over 5 years by 5slb6
1
answers202
Views
ALUMINUM
NO YOU DO NOT HAVE TO STRIP WOOD BEFORE PAINTING IT UNLESS IT IS PEELING VERY BADLY. YOU CAN BRUSH THIS WITH GOOD RESULTS ALL YOU NEED TO DO IS...
over 5 years by 5slb6
5
answers398
Views
STUCCO/EIFS
What you have is EIFS which is synthetic stucco not the old style concrete stucco that was used years ago. You most likely will not be able to ...
over 5 years by 5slb6
1
answers439
Views
Aluminum
Is this project outside or inside? Why do you need to strip the spindles?
over 5 years by 5slb6
5
answers727
Views
aluminum
You can get aluminum paint in either spray or brush on and it is just regular paint. I would go with the spray on as it will go on more evenly. The...
over 5 years by 5slb6
5
answers292
Views
wallpaper
If it is on the wall tight I say leave it there. If it was applied to the wall without painting or sizing then you will tear up the walls and will ...
over 5 years by 5slb6
1
answers53
Views
tank
I would hand sand it with rough sandpaper to remove the rust and peeling/flaking paint, oh if it is dirty and mildewed you will need to wash first ...
over 5 years by 5slb6
1
answers534
Views
ceiling
You need to get back to a sound substrate and then fill it in. If it is large or deep then you will want to fill it in with a product like Durabond...
over 5 years by 5slb6
1
answers802
Views
siding
I am not sure about a grant to pay for removal. If you do not disturb the siding then you do not have a problem with asbestos getting in the ai...
over 5 years by 5slb6
4
answers480
Views12
answers644
Views
