If the wallpaper has not been painted over it is not really to hard to remove wallpaper from plaster. I would get some DIF remover from your l...
I would think that you would not want to apply a lacquer over a conventional polyurethane or varnish as the solvents will lift them.
Sanding the surface and making sure it is clean are always good ideas. But I would not use a stain blocking oil based primer as they dry to br...
You do have a choice on a water borne primer that will adhear to the oil based trim paint and you should be able to get it a Benjamin Moore store. ...
I would not do it as it is Very difficult to get paint to stick to that kind of surface. It will start to peel and scratch off quickly and look ver...
I would wait at least a week for the paint to cure some. You may have to touch a few spots but if the installers a good there will not be to much o...
You could prime the entire surface with a latex primer and recoat with the latex finish paint. Latex paint can be sprayed but only larger sprayers ...
First off I would recommend not painting the counter tops as it will be a maintenance issue with the paint peeling and chipping off. You can pa...
If the tiles are new you do not really need an oil based primer. It may be better to just paint with just the latex finish paint.
You will need to remove the glue residue and this is best done with water and wallpaper remover. Then prime the walls with Zinsser GARDZ which will...
You will need to sand with fine sandpaper to dull the surface. Then wipe with paint thinner and follow with an ammonia and water wash to remove dir...
When you are talking about something such as siding does it really make that much difference.
I would go with the cement siding. It will hold paint better than the cedar as you do not have to worry about mill glaze, grain movement or knots. ...
Are you going to change the color? After you sand the furniture you will need to wipe it down with paint thinner and follow this with an ammoni...
There are two ways to do the handrails. First you can remove all of the finish either by sanding or chemical remover. Them you can stain the handra...
You should apply only one coat of primer as that is all you need, as anymore is just a waste. Then you can apply one or two coats of finish paint o...
I would wash it with ammonia and water first to be sure it is good and clean. Then you can prime it with a bonding primer such as Insl-X STIX and ...