bath fan timer keeps breaking
About a month ago we replaced the fan switch in our bathroom with a Lexicon 30 min timer. About 10 days later I noticed that it would not turn off...
COMMUNITY FORUM
Recent Posts
8 months by abfab04
0
answers730
Views
Do I need to vent furnace room?
I have an 8x8 ft furnace room with a 2x3 ft maintenance access door, plus an entry door. The room contains only the high efficiency furnace which ...
0
answers1180
Views
will never use plastic again
thanks. i ended up sawing the piece off. now using a brass valve instead of the cheap plastic crap!
over 3 years by abfab04
3
answers372
Views
water tank drain valve snapped
i was trying to replace a leaking plastic drain valve on my gas water tank but it broke off leaving part of the treaded piece inside. i tried usin...
3
answers389
Views
dripping toilet
the water level in the tank drops.
almost 4 years by abfab04
4
answers651
Views
dripping noise in toilet
this seems to be a common problem, but i haven't been able to find a solution... after flushing the toilet, a slow dripping noise can be heard f...
6 months by BV000044
4
answers1633
Views
lost window replacement
One of the windows of my house is missing the the two outside windows (the one next to the screen and the one that slides). Both are thermal windo...
about 4 years by abfab04
0
answers994
Views
thanks.
the difference would be over a foot. i wasn't sure whether it was better to have it closer to the pump or not. thanks for you help!
over 4 years by abfab04
5
answers356
Views
correct placement of sump pump check value
i just bought a new sump pump that requires a 1 1/4" hose to replace one that no longer works properly. the existing one has a 1" laundry hose, wi...
5
answers1520
Views
replacing tub spout
instructions should come with the new spout, however in case it doesn't... there is a small screw at the bottom that you need to remove (tool migh...
over 4 years by abfab04
9
answers131
Views
replace spout
you'll need to buy a new spout. standard ones are very inexpensive and easy to install. apparently you can't just buy a replacement stopper for t...
over 4 years by abfab04
9
answers70
Views
dryer heat
Thank you for your reply! While I had the back open i cleaned everything, including the vent, which had very little build-up. It only has one...
over 4 years by abfab04
3
answers486
Views
dryer heat cycle issues
I have a coin-op Inglis dryer (model TO-81001) which has a switch for permanent press, regular and delicate cycles. It came with the house and onl...
over 4 years by DanO
3
answers1207
Views
water heater shutting off
i have two identical gas water tanks for my home, one of which i've been having ongoing problems with. periodically i'd find one tank would stop...
1
answers155
Views
pedestal sink wrench
I found a special wrench made especially for this after doing some searching online. it comes in 1-1/4 and 1-1/2" sizes. i need the bigger one but...
over 5 years by abfab04
3
answers774
Views
replacing pop-up assembly of pedestal sink
this is my first time repairing a pedestal sink so would appreciate some insight... i have to replace the pop-up assembly of my bathroom sink be...
3
answers877
Views
toilet bowl rust
my tenant just moved out and I found the bottom of the toilet bowl covered in a thick rust coloured grime. I tried bleach and scrubbing with toile...
1
answers566
Views
buzzing gone!
After five days of this constant noise, 24 hours a day, its gone! I was cleaning the window on the adjoining outer wall and suddenly the noised st...
about 6 years by abfab04
6
answers299
Views
re: buzzing noise
its definitely not electrical and i don't have a wine turbine. I turned off the main power switch and sound is still there. the only items st...
about 6 years by abfab04
6
answers885
Views
identifying source of buzzing noise
A few days ago I started getting a constant high-pitched buzzing noise in my living room. It is only happening in this room, nowhere else. I check...
about 6 years by abfab04
6
answers1027
Views
