Buckling/Rippling of newly installed Engineered Hardwood Flooring
did you let the flooring acclimate for a few weeks before installing it? If not that is the reason it is doing what it is doing. If not, dont let t...
did you let the flooring acclimate for a few weeks before installing it? If not that is the reason it is doing what it is doing. If not, dont let t...
4
answers564
ViewsHmm this one reminds me of something I need to do. I am replacing 2 flourescent fixtures with a ceiling fan/light. This is on a 3 way circuit. Ques...
6
answers754
ViewsThat last post rings a bell. If an outside light is on a ground fault circuit, any leakage to ground will cause it to trip and if the leakage is co...
6
answers384
ViewsActually a dark bedroom is great to sleep in. One of our rooms is brown and guest say it was nice to sleep in since you didnt see light relections ...
2
answers353
ViewsOuch! I know that feeling, had it with drywall dust, gave me flu like symptoms and made me sick for weeks. Another wood to watch out for that is ex...
3
answers713
ViewsI think it is similiar, but has a rounded end instead of a flat one.
2
answers113
ViewsShouldnt be a problem as log as the stain had a chance to dry before you poly'd it.
1
answers744
ViewsThere is also a clamp system that uses 2x4's and is an over/under clamp. the units attach to the ends of the 2x and as it squeezes the wood togethe...
3
answers564
ViewsYou could make one. I took my seers saw and replaced the cast iron wings with partical board covered with formica,a nd routed in an opening for a r...
5
answers796
ViewsWhat Zone are you in? you need that in order to determine the BTU's required for that area. I have used the propane 99% efficient space heaters tha...
1
answers942
ViewsYep it is called an ejection pit, for which you would need an ejection pump. The pumps run around $250 and worked the same as a sump pump, but can ...
2
answers997
ViewsI had a house that the floor sloped towards the drain in one corner of the house, it sloped quite a bit actually. Instead of messing with the slope...
5
answers69
ViewsI have the same exact thing your describing. A long ranch house with great distances between the heater and the faucets. What I have com eup with i...
1
answers286
ViewsIf there is a wash tub, you could put the washer next to it and attach the hose to the faucet and hook the drain onto the tub. I did that in a hous...
4
answers243
ViewsI would suggest a Jenn Air slide in for the island with the down draft built in as long as you have access under the floor to run the ducting. The ...
2
answers349
ViewsMinimum 15 amps if it is by itself, if other appliances are on the same circuit, then 20 amps would be needed.
5
answers401
ViewsIf you have cats, dont get an electric unit, I have heard horror stories of cats jumping up on units after they have been turned off and having the...
3
answers880
Viewsyour down force, or the revers mechanism are out of adjustment. there are knobs on the unit that are marked upforce, downforce and not sure what th...
2
answers659
ViewsIts not the moisture that its designed for, no wood is good around moisture, you must first test to make sure there is no seepage through the concr...
1
answers539
ViewsConsider the fastners each one uses, they arent all the same. Cost of fastners may help determine which one to get, considering they are all good m...
2
answers652
Views