Recommendations for tools - Brand??
Porter cable has the best bang for the buck when it comes to the miter saw. As far as a table saw, stay away from crapsman!!!!! I have one with the...
Porter cable has the best bang for the buck when it comes to the miter saw. As far as a table saw, stay away from crapsman!!!!! I have one with the...
6
answers388
ViewsVery carefully! You can use a machined straight edge and measure straight across with the bed zero'd out, and measure diagonally also. Geeting the ...
1
answers178
ViewsI would also have the pressure to and after the regulator checked, the new gas company may have replaced the outdoor regulators withtheir own brand...
1
answers98
Viewsoh been there done that almost blew up the house in the process. If you cant find the part chances are the furnace is way too old and should be rep...
2
answers177
Viewsheh funny dude!
3
answers560
Viewsthe answer is no it will not withstand freezing. they work by the amount of water being sent through the tubing, when water is not flowing the unit...
2
answers526
ViewsBeing that it is a garage, having HVAC in the same area can have deadly results by allowing exhaust from the vehicles into the living areas. Using ...
3
answers587
ViewsDefinately get out of it. not only is the foundation cracked, but over time that crack will work its way all the way to the top of the house, and y...
8
answers542
ViewsPersonally if I were looking at a home and the foundation had cracks larger than a hairline, or longer than a foot, I would walk away from it.
2
answers451
ViewsDude from experience, dont do the mix by yourself, have it trucked in. I mixed an 8 x 12 patio by hand with a mixer and the concrete started to set...
4
answers61
ViewsAll the codes I have dealt with require any new footings that are to be attached to an existing structure are to be identicle to the existing struc...
2
answers402
ViewsThey used to use aluminum wiring in mobile homes years ago, but disimilair metal corrosion had caused a lot of fires and thats the main reason you ...
6
answers699
ViewsI have one on my barn that does the same thing when its wet out. Of course one of the attaching screws is missing, so I assume thats why, I'll have...
5
answers622
ViewsThe main panel GFCI breakers are good if you are doing new wiring, or want to protect the entire circuit, the outlet units are if you just need to ...
5
answers77
ViewsPower is being supplied to the 4 way switch. the other 2 3 way switches just make or break the circuit depending on the position of the other 2 swi...
2
answers429
ViewsQuick tip. Use 2000 grit wet/dry sandpaper and a spray bottle filled with water and dish soap. mist the surface and lightly sand in a circular moti...
2
answers233
ViewsYou will need to get the structure repaired first before any plumbing work can be done. Best bet is get someone who can do both jobs.
9
answers236
ViewsI've nailed 2x4's into the beam with a high velocity nail gun. Those work quite weel, if you can still find one.
2
answers499
ViewsIm curious why there is a beam in such a small garage? Is there a second story above it? Most 20' garages just use ceiling joists to span the dista...
2
answers32
ViewsDont know about the system, but from what I have experienced in my house, I can give a few things to look for. First check the gutters. I found tha...
1
answers979
Views