Gutters and valleys
Thanks, when they installed the seamless gutters on my house I dont think they pitched them properly, 3 of the 6 overflow when they get close to th...
Thanks, when they installed the seamless gutters on my house I dont think they pitched them properly, 3 of the 6 overflow when they get close to th...
4
answers647
ViewsHey Lawrence, PHHHTTTT :-P Ford Rules, dodge and chevy drool!!Tha said, the Behr I have used so far, egshell excluded has been pretty good, one coa...
14
answers306
ViewsDepends on the type, the tankless ones will save up to 50% energy costs over any other type of water heater, except of course the ones that are hea...
2
answers511
ViewsBUMP
4
answers136
ViewsThere are many aftermarket companies that sell rip fences for table saws. There is even an incra jig, one which I use and love that will fit any ta...
1
answers620
ViewsFirst question, is it real wood? If it is then yes it can be refinished just like any hardwood floor. If it isnt real wood, no you cant refinish it...
1
answers194
ViewsSure, I have a full view glass storm door in front of my steel door with double pane brass glass door, You want to be carefull if the door is wood ...
1
answers548
ViewsThe honda one will be the most reliable, also the higher the pressure the better it will clean. If it was a hot water washer, then lower pressure i...
2
answers106
ViewsMake sure that when you release it you push the gun down onto the rivet. You want the rivet to be tight against the surface your riveting and also ...
4
answers830
ViewsWhat is the drop per foot on a gutter for proper drainage? Also what can I do to prevent or at least slow down the deluge of water that comes off t...
4
answers602
ViewsA reverse osmosis filtration system will produce water that is pure, it removes everything from the water and what comes out is water like you woul...
7
answers765
ViewsHmm, a paint can of worms, like that. Just finish my room with deep burgandy eggshell behr paint. Took 4 coats since I used untinted kilz on everyt...
14
answers977
Viewscyanoacrylite adhesive remover is what you need, Test it in a small unseen area first to make sure it wont stain or damage the material.
2
answers175
Views50 pounds per 1000 SQFT to reduce acid levels by one. Mind block, cant remember if raising PH is alkaline or acid, either way Lime reduces the acid...
2
answers924
ViewsYou will need a good strong back and a shovel. Once you master the use of the shovel the rest is easy. Dont put it around trees, the roots are a pa...
1
answers202
ViewsLook for a finish that has either aluminum oxide or is a ceramic finish and you wil have found the hardest surface for your application. Dont go to...
4
answers930
ViewsSimple answer. Without the tape, the seams would crack.
1
answers775
ViewsThe jenn air has some nice features, and is made by Maytag now. There are some other high end models, but I have heard repairs on them are frequent...
2
answers503
ViewsAlternative to that would be to put 1x4 PT down with a vapor barrior and then lay plywood on top of that. You will need to either shoot the 1x4 wit...
6
answers206
ViewsWater pipe is sweating. If its behind the wall, you will need to expose it and wrap it with insulation to keep it from sweating. That will be the o...
3
answers421
Views