Washer
Hi, I know very little about these....but something below may help.... http://www.applianceaid.com/calypso.html jeff. Appliance Repair Ai...
Hi, I know very little about these....but something below may help.... http://www.applianceaid.com/calypso.html jeff. Appliance Repair Ai...
1
answers332
ViewsPages 3-4 3-5 is good for checking switches. http://appliancehelp.hypermart.net/xmb_neptune_mah3000.pdf A phsical inspection of the machine con...
7
answers442
ViewsHi, **Water drains OK** Good :) Some helps... http://www.applianceaid.com/neptune11.htm http://www.applianceaid.com/neptune10.html ht...
7
answers162
ViewsHi, Model#? http://www.applianceaid.com/model.html Some model# helps. **This time it will not spin dry the clothes** Water drains out ...
7
answers601
Views** Where would you start to look to repair it?** I'm with Dan...rear drum bearing and front support glides are likely worn and should be checked...
4
answers447
ViewsHi, **How do you tighten the drum** You wouldn't...why do you think yours is loose?...the drum should turn fairly freely and move up and down...
4
answers565
ViewsHi, This might help as well.... http://tinyurl.com/b4aw4 jeff. Appliance Repair Aid http://www.applianceaid.com/ JRAppliance http://ww...
9
answers33
ViewsHi, **how do i identify** The dryer?....by model#. http://www.applianceaid.com/model.html 80 series isn't it! ** and chnge the heating e...
1
answers285
ViewsHi, **This is what I have: the pulley shaft turns normally in one direction, and I can see the agitator shaft moving in its normal motion. Howev...
1
answers636
ViewsHi, **My gas range was not heating up all the time** By range you mean oven? If yes, a weak oven ignitor can do that. http://www.appliance...
1
answers36
Views**And yes, the water has drained** That -should- mean the lid switch is working. jeff. Appliance Repair Aid http://www.applianceaid.com/ J...
4
answers154
ViewsHi, **110, Ultra Fabric Care 80 Series, serial # 92389200** That model# may be 110.92389200 **It will run through the wash and rinse cycle...
4
answers23
ViewsHi, Likely will have to disconnect the drain plumbing to clean it out and possible even remove the unit from it's mount to clean up the clogg. ...
1
answers318
ViewsHi all, **dryer gets very hot on top and around control knobs. clothes still damp after one cycle** Kinda sounds like poor air flow...fan blo...
2
answers476
ViewsG'day, **Model 362.72220** Too short, I found 362.72220200 362.72220201 362.72220202 362.72220203 362.72220204 **The oven ignites. All b...
3
answers213
Views**Yes, the washer does drain the water out** That -should- mean the timer is telling the motor to reverse and the motor is reversing. Drive p...
3
answers394
ViewsHi, **It agitates and during the spin cycle** Does the washer drain out the water? The motor should run in one direction for agitation and th...
3
answers361
ViewsHi, **the oven is a Kenmore, about 3 yrs old** Model#? Gas, electric? Range or build in oven? http://www.applianceaid.com/model.html Some mo...
3
answers314
ViewsFound this ( yours right? ) in another forum.... ** I checked that nut you were talking about and its tight, if I start the spin and then stop i...
6
answers506
Views