DO NOT INSTALL SIDEWAYS!!!! The copressor will burn-up because the oil will run into the condesor coil and the moving parts of the compressor will...
Just realized that I didn't answer your question re. wood windows. Wood is fine. It just requires more maint. than vinyl. Also, you may have tro...
Hi Dream:Don't understand where you "punched holes" or why. Is water streaming down the wall this bad because of a driving rain or run-off from th...
I just went through the same thing. My house was built in 1908 with 50 double hung windows. I would make the following sugestions.1.) remove the ...
I purchased some wallpaper from National wallpaper a couple of years ago and have lost their phone # and web address. Does anyone have this info?T...
This is a supply source for all kinds of hard to find hardware. Good luck, Bill http://www.dawsonsupply.com/
Check the reply I sent to Carrie "sewer oder". the "blurping" sounds are the result of improper venting. The reluctant flush problem is indeed a ...
Check the answer I gave Carrie on "sewer oder" on MAr 16. You have the same problem.GOOD LUCK,Bill
Check your vent stack for the bath sink. I bet it is stopped-up. When it stops-up, the water flow from the sink actually siphons the water out of...
Your problem may be the storage tank is "water logged". To fix it is simple. Turn off the pump and drain all the water from the tank. After all ...
Go to your Olympia dealer. They are reconigized as the best in the industry forr clear wood treatment. Go by their directions explicitly.GOOD LUC...
Absolutely a must!! I would recommend a 1"X2" "DL" drip edge. This should have been installed prior to the starter row (first row) of shingles. T...
Lots-a-luck. Don't mean to be smart, but when the warm moist air in your house rises and hits the cold window, the basic law of physics dictates t...
Your leaking windows are the result of poor or no caulking. Since you are using storm windows , I presume you are up north. I would recommend a v...
Unless the items were spelled out in the original contract or you signed a change order, you're not obligated to pay. If you signed a standard AIA...
I just bought one at Home Depot. It had all the hardware you need including the rough-in special metal clad wood studs, and heavy duty track and r...
Need more info. what type of wall is it fastened to? Do you want to save the mirror and how much trouble are you willing to go to? Is it framed?...
Miz Em: Masonite can be cut, nailed, or glued the same as plywood. any saw (hand saw, circular, copping etc.) will cut it. As to cutting a strai...
good advice. I'd add that most screens are laquered to prevent just such and occurance . I would recommend that when the spots are removed, clean...
The simple answer is yes, but...To get a professional job you will need spray equip (as used for auto painting) and the skill to use it. I just pa...