Franklin Chef Icemaker
The LED that I am talking about is on the left side, over the On/Off button. To the right there is, in order a making ice mode LED, a harvesting...
The LED that I am talking about is on the left side, over the On/Off button. To the right there is, in order a making ice mode LED, a harvesting...
3
answers384
ViewsModel FIM44 The red LED on the front is lite and the On/Off button does not do anything. I don't know if the red LED means that it is in the ON ...
3
answers1102
ViewsSounds like you have a leak. Get under the sink with a flash light and check all over for a water. And check with while some one has the fauc...
1
answers587
ViewsAs long as there is more than one receptacle on the circuit the code specifically allows 15 amp receptacles on 20 amp circuits. And duplex recep...
4
answers138
ViewsThe bammer has problems, but I don't know the details of them. I has been discontinued. I think only a couple of years after it was introduced. ...
40
answers104
Viewshttp://www.carrollparts.com/5_contact/5_contact_frameset.htm
17
answers659
ViewsI have never done this. So I don't know how hard it is. But the connections and the transformer are suppose to be accesable. And you are supp...
4
answers937
ViewsIt sounds like the light sockets and/or wiring in it is bad. Most likely the socket can be replaced and rewired it needed. Or a new light kit ca...
2
answers282
ViewsYou need at least one 20 amp circuit to serve the bahtroom receptacles. If there are no other bathroom connected to it you can also use it for t...
2
answers43
ViewsWhile that first sanding is only to knock of the tips that are sticking up above the average. They will catch the blade when you skim coat and you ...
7
answers273
ViewsYou want to give is a coat of sealer. There is one, Gardz, that is ideal for this. http://www.zinsser.com/product_detail.asp?ProductID=27 ...
7
answers243
ViewsStart with Van Dykes. http://www.vandykes.com/category/hardware Also google on terms like Antique pocket door hardware and Restoration pocket...
1
answers957
ViewsBut you need to see if you have space and holes in the wiring box for the both cables and connections. I have not done a fan/light combo. But th...
7
answers59
ViewsMost wood lathes uses standard sizes for the threaded and tapered drive and tail stocks. And there are many 3rd parties that make accessors. ...
9
answers733
ViewsFirst I want to make it clear that there are two types of "surround" wall systems. The first are ones that are designed to be installed over dry...
3
answers431
ViewsNow moisture might be wicking through the walls. But I think that you have too high an internal mositure level. In older homes air leaks out ...
1
answers735
ViewsMost of those were Direct To Stud. There is nothing behind them. For the ceiling you will need to drywall it. That is unless you put tile over i...
3
answers719
ViewsThere is no way of telling the diffculties from a distance. If this over an unfinished crawlspace or basement the then you can do it completely ...
4
answers610
ViewsYou did not give any indication of what the "unforeseen complexities" are. And even with them what you should "wait for". I don't know if are ta...
4
answers830
Views