NEW LANDSCAPING
Those are harsh conditions that most of do not deal with. What works really well in the mid-west won't work in those extremes.Check with some loca...
COMMUNITY FORUM
Recent Posts
almost 11 years by BobF
3
answers90
Views
Proper way to water newly seeded lawn.
Once its been mowed a few times, then water only twice a week - 1/2 inch each time is enough. Any more and you are wasting water. If you do it ev...
almost 11 years by BobF
4
answers711
Views
Counter Top
Alan,Sorry none of us can give a good answer.Take your question to the forums at www.woodmagazine.com They have a forum dedicated to finishing issu...
almost 11 years by BobF
8
answers834
Views
Phones work (receive & sending) but do not RING..... ?????
It used to be that too many phones connected would cause problems. Each phone had a number and you added up these numbers. If the total was too h...
almost 11 years by BobF
6
answers101
Views
Proper way to water newly seeded lawn.
You are correct. For new seed you just want to keep it moist - not soaked. Your neighbors are indeed wasting water.
almost 11 years by BobF
4
answers380
Views
Power Sprayer - Which model?
To keep it white and still spray, you will need to plan on one of two things: either mask the trim or repaint when done spraying.Some sprayers mini...
almost 11 years by BobF
1
answers365
Views
What is a soft water loop?
1. Don't use softened water on outside bibs - why waste softened water?2. Many people have the mistaken belief that softened water has a high sal...
almost 11 years by BobF
15
answers505
Views
Adding GFI to existing washer outlet??
How's this - instead of tapping into an existing circuit why not run a brand new circuit? The extra cost is minimal.
almost 11 years by BobF
9
answers354
Views
Adding GFI to existing washer outlet??
Yes, you are correct.The dryer outlet is probably 220. Don't even think of tapping into it.[This message has been edited by BobF (edited May 21, 2...
almost 12 years by BobF
9
answers691
Views
Pulpit/Podium
The one's I've seen are simple cabinet carcasses with fancy trim work on the outside. I suggest he visit a few churches and make note of what he l...
almost 12 years by BobF
1
answers120
Views
paver blocks over concrete??
If the concrete is in good shape, then definitley go that route. You use thinner pavers and mortar them to the concrete.Visit a brick/paver retail...
almost 12 years by BobF
2
answers643
Views
Painting New Ceiling
How do you know he didn't wipe the dust off the ceiling before priming?
about 11 years by BobF
2
answers620
Views
Back Yard problems
No need to remove the existing top soil.Kill the existing grass. Rent a seeder and cover the lawn in 2 directions.Check with the local nurseries b...
about 11 years by BobF
2
answers761
Views
Retore Trim
As for the piano, the value depends on the type and maker. If its an upright you probably won't lose much value and may even gain value. If its a...
about 11 years by BobF
2
answers47
Views
Can I take 1/2" off from under my counter?
Along those lines, you may not even need to cut it at all. Lift it up and slide the washer under it. The counter is probably secured with just a...
about 11 years by BobF
3
answers177
Views
router bits
Only you (significant other) can answer that question. The final look is a personal decision.
about 11 years by BobF
2
answers355
Views
Painting over wallpaper
I've never heard of "ten test" wallboard. Is that a local term?Painting over wallpaper is a bad idea. Water from the paint will cause the paper t...
about 11 years by BobF
1
answers673
Views
help! best way to build stable & sturdy shelving?
To answer your question: Do not use adjustable shelves for the base shelves. They must be secured with nails or screws. Better yet, fit the shel...
about 11 years by BobF
2
answers26
Views
2-prong outlets replacement. HELP................
Savannah,The boxes we are talking about are the little boxes that hold the outlets, not the fuse box or circuit breaker box. Nowadays, they are li...
about 11 years by BobF
13
answers805
Views
2-prong outlets replacement. HELP................
The metal boxes may (should) be grounded. If so run a wire from the grounding screw to the metal box.If the boxes are not grounded, make sure the ...
about 11 years by BobF
13
answers372
Views
