Laminate cabinets
You can use a iron to heat up the laminate and use a putty knife to scrape /cut the strings of adhesive conecting the two.then use laqure thiner to...
COMMUNITY FORUM
Recent Posts
about 7 years by cabmakersk
1
answers997
Views
Tankless
yes it can (i have one) but for us only on high demand (tub) that is has a problem. the more gallons per miniute the less it will be.we dont even n...
about 7 years by cabmakersk
1
answers559
Views
radiators
you do not put air in your system the air came out of the water an that was probibly the highest point and air gose to the top. so just blead ontil...
about 7 years by cabmakersk
1
answers83
Views
table
first you buy a good striper and strip it clean then sand a little non seen place if it is staind (it might be a light wood ) sand it off a use t...
about 7 years by cabmakersk
0
answers925
Views
Melamine
Melamine is a good way to go (price and durabitity) melamine is a poly coverd particle bord. as long as they are installed corect they are very go...
about 7 years by cabmakersk
1
answers420
Views
craft
Get some books they will give you ideas then look into workshops or night classes to get more hands on wich is the best.
about 7 years by cabmakersk
1
answers188
Views
stain
first you have to determine if there is a sealer e.g(polyurithane) as no stain will work.you do this by trying to scrach a area and see if anythin...
about 7 years by cabmakersk
2
answers927
Views
rockon wall
screw lathe to the wall so the mortor has somethig to bind to good luck
over 7 years by cabmakersk
1
answers69
Views
murphy bed
www.leevalley.com they have kits and plans.
over 7 years by cabmakersk
1
answers735
Views
Steel or wood
Wood is better for basments because of rust and wood is more secure. Be sure to place a barier between the cement and wood.also wood is a lot bette...
over 7 years by cabmakersk
1
answers143
Views
INSULATION
INSULATION prevents the transfer of heat.best way to check is to make a small hole (behind base bord is good ) and fish around to see if you pull a...
over 7 years by cabmakersk
1
answers549
Views
dust
Sorry fiberglass looks like cotton candy and is pink or yellow
over 7 years by cabmakersk
3
answers139
Views
dust
Most likely if just a little it is drywall dust or plaster
over 7 years by cabmakersk
3
answers657
Views
Smelly house
From what you say it vere well could be a mold problem in your walls.First you have to stop the water from coming in (were ever it may be) it also ...
over 7 years by cabmakersk
3
answers402
Views
instantaneous water heater
Yes it is. im just wondering if i can put a heat exchanger around the hot to heat the realy cold water so there is not as big of difrence in unheat...
over 7 years by cabmakersk
3
answers40
Views
home security system
Could be the charging system or a short some ware but good luck
over 7 years by cabmakersk
2
answers867
Views
cabinet door
The best would be to fix it faling that a cabinet company should be able. Also there are company that just make doors. Good luck with the 5 year old.
over 7 years by cabmakersk
1
answers482
Views
MDF Cabinets
I have been working with mdf for years number one thig is to use 3/4" and the best grade posible. yellow glue ,pre driled #8 wood screws,and biscui...
over 7 years by cabmakersk
1
answers556
Views
What type of adhesive for 3/4 stair nose
I think the best glue would be polyurethane (E.G gorila glue) It has the strength of epoxy but no mixing. just be sure to dampen the board first. c...
over 7 years by cabmakersk
1
answers648
Views
exchanger
Sorry about that. Its a used tankless electric 2.5 gpm. I want to install it into my cabin up north It says Jc1 on the box pretty sure it is a cana...
over 7 years by cabmakersk
3
answers362
Views
