4' x 4' Granite Tile Entry Installation -- HELP!!
i talked to my tile installer about the lino,his answer,dont do it.if your cement slab is clean and smooth install on that. if you have cracks in ...
i talked to my tile installer about the lino,his answer,dont do it.if your cement slab is clean and smooth install on that. if you have cracks in ...
5
answers196
Viewsyou can,butyou will raise up the level of the floor(poss.trap your dish washer)if some time in the future you have a leak from the dish washer or r...
2
answers686
Viewsi have always put the cabinets first,and the finished floor later.less chance to damage the floor.appliances can sit an a laminate floor,no problem...
1
answers5
Viewsi'm not sure about the lino.i have a tile contractor that works with me , i'll ask if he thinks its a good idea.(i don't think it will be)
5
answers897
Viewsare you pulling up the existing marble? i hope the answer is yes.does your entry open in to your living room?are there walls? will the place you pu...
5
answers582
Viewsyou will need a seven foot long level,most laminates require the floor be level to about 1/8 in 10ft. you can lay over the existing sheet vinyl,but...
4
answers468
Viewsi'm sure you did fine,when the floor is dry spritz a little water on it and make sure it beads up.good luck
3
answers374
Viewstake a look at a baby threshold (from any wood mgf.) it will overlap your tile .and you can install it over the existing carpet.good luck
2
answers214
Viewsi posted a reply to mark for his problem.bubbles come from gassing off.you can roll the floor all day and still get them. a roller was used by floo...
5
answers634
Viewsyes,you will need to buy it at a flooring supply store,its a circular saw.with an extended shaft,it has a 3 1/2 blade. its called a toe kick saw.go...
1
answers989
Viewsi think your bubbles will have gone by now all on there own (vinyl will bubble on most installs) if you still have any after 10 daystake a heat gu...
1
answers253
Viewsyou can add additional coats of sealer if needed.you can tell if water beads up on the tile and grout your o.k.,if not add additional untill it doe...
3
answers62
Viewswell lets start at the begining.you do not need any additional underlayment.a jigsaw is enough ,but a small table saw would be better.fix the squee...
4
answers701
Viewsin order to answer your question i need more information.what tile(size ,type) what adhesive,what did you install the tile to.(plywood/p-board /cem...
1
answers189
Viewsits possible i/2 the boxs were miss marked,forget what the installer said.when the mgf rep come's by, be firm & friendly,ask "would you want this i...
3
answers220
Viewsi'm not sure if this helps ,but wood has no dye lots. only diff.colors(gunstock,toast,spice ect.)was the wood that was installed all the same color...
3
answers97
Viewsdon't worry to much about the asbestos,you can only release it if you sand the floor,vacume any dust you see,pull up (scrape)the floor,vacume again...
1
answers261
Viewscongoleum ultima is the best value in sheet vinyl today,you can buy it at home depot for $19.99 s.y.,you can roll it if you want to ,but i dont thi...
5
answers718
Viewscall a pro,this is not a d.i.y. project,good luck
2
answers172
Viewsi dont think you should try the backerboard over your cement,what i would try is to use a self leveling cement to raise the level of your floor,i t...
2
answers597
Views