Repair/Replace Shower Tiles
you may not like this answer,but...you will need to remove all the tiles off all 3 sides of the tub,just smash them out clear every thing down to t...
you may not like this answer,but...you will need to remove all the tiles off all 3 sides of the tub,just smash them out clear every thing down to t...
1
answers403
Viewsyou need a floor scraper,cost about $6.00 from home depot.(make sure the blade is in the correct way, its often sold with the blade in backwards)wh...
6
answers836
Viewsmarble is a very soft natural stone,that is easy to scratch and stain...that said,don't worry to much find out if the floor has been "sealed" how o...
2
answers9
Viewsi don't see why not...but if you use a air compesser each "hit" will be the same,that hammer gets heavy after a few hours....good luck
5
answers318
Viewspull everything down to the studs,then replace in reverse order......good luck
3
answers455
Viewsdon't worry ,it wont be a problem...
2
answers508
Viewstry this websitehttp://www.bellawood.com/...good luck
2
answers979
Viewsfind the biggest hardwood flooring shop in town (or close big city) and look at lots of samples.find the one you want ,and then shop for price.......
1
answers21
Viewsyes a lot of lino and vinyl floors will shrink .there is normaly a reason due to temp.extreme heat or cold,also some sheet vinyl is glued at the ed...
1
answers999
Viewshave you contacted pergo to see if there is any in there system,it would have been sold by home depot,but i doubt they would have any.(they have a ...
1
answers871
Viewsi assume this is not 3/4" solid.(you said stapled.which would be a thinner product.) however its done the same way.SLOW. get under the wood were it...
1
answers934
Viewson any peel and place product i always add additional adhesive,dry back or peel and place ,i always add glue....having said that.wood parquet will ...
1
answers700
Viewsyou for sure can not install over your existing subfloor , plywood will be required. 1/4" should be o.k.(the reason is that the glue that holds the...
7
answers389
Viewsthe normal adhesive would be "thin set mortar" with the additive,(if needed)...good luck
1
answers802
Viewsperlite hold water ,that might be the reason? but it is not done that way in my area,call another local contractor and ask if they do it that way.....
1
answers32
Viewscut your plywood about 3/8" to 1/2" past the front of the cabinets,drill holes in to the support,then screw down the plywood,if you are using 3/4" ...
2
answers653
Viewsarron..i dont think you will be able to round off the edge your self...but the people in your area that sell granite counter tops could do it for y...
11
answers928
Viewsyou don't need one (hardibacker is waterproof) but it would be a good idea to install one....good luck
1
answers784
Viewsi don't know any great web sites,but look for ideas in "tile only" shops and books on tiling.....good luck
3
answers308
Viewsthe big stores like home depot are about stuff they can turn (sell)over in big volume to justify the low prices,find a local "tile only" store to g...
2
answers18
Views