Repolishing Corian top
It can be restored to look like new, but you need a random orbit sander hooked up to a vacuum to do it. Start with 220 grit sandpaper, then 280, th...
It can be restored to look like new, but you need a random orbit sander hooked up to a vacuum to do it. Start with 220 grit sandpaper, then 280, th...
1
answers463
ViewsIs the saw belt driven or direct drive. If belt driven, any motor with the same HP rating & Frame number should fit right up. Sometimes different f...
9
answers703
ViewsIf it's another solid surface, it's called "Simplicity", and it's made by Montelli, a Chinese subsidiary of DuPont. It comes in limited colors whic...
1
answers753
ViewsAll you need to support the banjo leg is a cleat on the wall behind the stool and on the end wall. Engineered stone, which is what Caesarstone is, ...
3
answers830
ViewsUnfortunately this is not a DIY job. The damaged area needs to be routed out very precisely and a new piece of Corian cut to fit and seamed in. The...
3
answers117
ViewsIf it's the moulding I'm thinking of, it's meant for laminate tops and has a flange that goes under the laminate before the laminate is installed. ...
1
answers541
ViewsNot very successfully. You can paint it if you rough it up enough, but even that is not very satisfactory. Laminate is nonpourous so coatings don't...
1
answers559
ViewsWhat probably happens is the heat destroys the sealer on the granite allowing stains to penetrate and darken the surface. The granite itself was fo...
6
answers614
ViewsThe easiest way is to use Wet Or Dry sandpaper (220) wet followed by 400, then red Scotch Bright pad to bring satin finish back. Go over entire top...
1
answers969
ViewsYou can cut it with a circular saw using a carbide tipped blade. A triple chip blade used for cutting aluminum or brass works best, but a standard ...
4
answers556
ViewsTry dry Portland Cement powder. It may take a while, but it will eventually pull it all out. Just sprinkle it on covering all stained areas and lea...
2
answers947
ViewsIt depends on the condition of thr surface. If it's just normal wear with scratches in the surface you may be able to get rid of most of them with ...
1
answers103
ViewsThe two largest manufacturers are PhotoTop and E-Template. They use a series of targets placed on the cabinets and walls along with a spe...
3
answers713
ViewsIt's almost impossible because they get in all the nooks and crannies of your house such as under the siding, around windows, etc. A non toxic way ...
3
answers622
ViewsThe answer to this question is that it's difficult to buy Corian adhesive if you're not a fabricator. All major brands have their own proprietory a...
5
answers810
ViewsIs this a new top? If so, and you hard mount the sink with adhesive, you'll void the warranty on the Corian because DuPont will not stand behind mo...
1
answers649
ViewsIf you have a coved backsplash, someone paid a lot of money to get it. It's the most waterproof and easiest to clean backsplash there is. To remove...
1
answers222
ViewsYou may be able to use knives for the old model Rockwell Homecraft 4" jointer. A Delta dealer can look up the part no. for you. As for the drive be...
1
answers260
ViewsMy wife always uses vinegar in a spray bottle to neutralize the odor and discourage resoiling the same area. She starts by absorbing as much pee as...
2
answers483
ViewsTo cut the tops to length use a circular saw with a carbide blade guided by a straight edge clamped to the top. Generally you would cut tops flush ...
5
answers696
Views