Learn and Plan to Live
Good point about circulating the back drafted products through the house, notably all the bedrooms on the second floor. Fortunately we didn't have ...
Good point about circulating the back drafted products through the house, notably all the bedrooms on the second floor. Fortunately we didn't have ...
1
answers639
ViewsHello again. My house was built in 1995. I have been trying to correct a poorly design/poorly installed HVAC (gas heat and central A/C) system ...
1
answers994
ViewsI have ran a HEATPRO1 model of my second floor room by room and computed a heating load of 37,246 btuh, the furnace serving this area is 79k btuh n...
6
answers48
ViewsI had the blower wheel and blower motor replaced 2 summers ago by a service tech (Lennox furnace with A/C). I didn't notice at the time but the tec...
0
answers333
ViewsWell its 7.5 months since we first discussed this topic. Since then I have had the bonus room floor insulated from the garage by removing the garag...
6
answers278
ViewsThanks for the continued guidance HK. If 150 cfm is 6" then if I work backwards to achieve similar flow (FPS) I get 270 cfm for an 8" round and ...
6
answers657
ViewsWell now my dilema. How to add returns 15 years after the fact without ripping open a lot of finished rooms. My house is new enough that all return...
6
answers93
ViewsOK so I ran calculations for heat dividing the three areas of the master suite into bed, bath and sitting room. The results were: Bed Bthu 3775...
6
answers841
ViewsThanks HK, One of the returns in the bonus room runs from the cold air (CA) plenum in the basement through 6in round duct (insulated). Extending...
6
answers653
ViewsI have a bonus room over a triple car garage in a 15 year old house. The room was finished with the original build and had HVAC and insulation thro...
6
answers1196
Views