But you have normal pressure when you just have the cold water on?
Are you only having that problem in the shower? I'd start with cleaning out the shower head. Sometimes shutting the water off and turning it back...
Of the bed or the dresser? The bed is from these plans but I don't have pictures yet http://ana-white.com/2010/05/furniture-plans-loft-bed.html
I painted a dresser with a base coat of Zinser and then 4 thin layer of Valspar semi gloss white. It's cured over two weeks now and it still chips...
when we had issues with our stove, we were able troubleshoot it through this site - http://www.repairclinic.com/Range-Stove-Oven-Troubleshooting?re...
Once asbestos starts to crumble, it really should be removed. Your state regulations will determine whether that's easy or not. At the time we re...
My parents have rental houses where the renters smoke heavily, to the point that you choke walking in the door. They always used two coats of Zinz...
It sounds like it might be a humidity issue in the house. Sometimes a dehumidifier in the room will help while other times you might need to direc...
Did he seal the old paint with a primer? Two coats of primer should seal it in. Then ask that a low VOC paint be used as the top coat.
We ended up using red oak for the bed itself, white pine for the bookcases and poplar (if I remember right) for the pieces that would take the most...
No, if your oven has a digital temp control, it's a little more complicated to calibrate the temp. If it's manual (older models) then it's slightl...
You'll need to mud it first, sand it down smooth and then get some texturing spray from your local home store. Practice with it on a piece of card...
Sometimes food can get trapped in the garbage disposal. You can put fresh lemon slices down in there and run the disposal. It will break up the f...
http://www.architecturals.net/star-birch-seatboard-15/ That might be what they're referring to.
the control panel is around $200-250. If you're under warranty, I'd start poking at technicians to start replacing things until it's working prope...
What have the technicians replaced? There are a LOT of complaints about this issue online. Timer, a bad motor control, a bad pump motor are a few...
I would think that LED is the best. Here's a comparison chart though - http://eartheasy.com/live_led_bulbs_comparison.html
I would also do a test cut to see if the wood is going to chip as you saw through it.