Miter Saw - what do you recommend?
If all that you want it for is to cut 2x4's, I wouldn't worry about what you buy. However if you want to cut moulding thats another mater. Type i...
If all that you want it for is to cut 2x4's, I wouldn't worry about what you buy. However if you want to cut moulding thats another mater. Type i...
6
answers46
ViewsWell your the one standing under it! If your set on removing the entire flue, I would guess that you would like to use the space. If the flue is ...
8
answers3
ViewsDo not knock it out! only cover the flue inlet. If you want to remove the whole flue then its wall removal time.
8
answers929
ViewsSounds as if your gas water heater does not have an expansion tank in the hot water line.
2
answers17
ViewsOnly if the light and fan come at the same time, best bet is to pull another switch loop for the fan.
4
answers847
ViewsSeal the wood before you put the tile down, grout as usual, then seal the tile. Just get in the habbit of cleaning up any spilled water.
1
answers301
ViewsThere are several ways, purchase a small wonder bar (about 5" long) hit right at the nail, or use a (GASP!) wood chisel. The tack strip will spli...
3
answers856
ViewsTight budget or not you need a big drum sander and an edger, DO NOT rent a vibrating pad sander. As far as the patches, you can do several things...
1
answers696
ViewsWow, lotta stuff to cover, to start the highet the R value the more insulating value. So R-30 is over twice the value of R-13(typical 2x4 wall). ...
2
answers76
ViewsOnce you use up all of your elbow grease on polishing up the kickplate, spray it with a clear exterior finish.
3
answers805
ViewsLow-e glass cuts down on solar radiation, I live in the pacific NW and it is used quite a bit up here. As far as spacing in glass 1/2" is good en...
3
answers481
ViewsIt sounds as if what you are seeing is the taped joints in the drywall, I assume that the ceiling is smooth, no popcorn or orange peel. If the hou...
2
answers982
ViewsLike matches said you'll get several opinions. Install pad under the carpet if you dont the carpet will wear faster, use the recycled foam (blue) p...
5
answers263
ViewsPropane tanks, depending on size have requirements as to how close to a house they can be, unlike oil tanks which can be set right against a wall. ...
1
answers815
ViewsIs the chimeny on the outside of the house or up thru the center of the roof? If it is on the outside no problem, start at the top and start knock...
8
answers650
ViewsInstall the polystyrene directly to the concrete, then build your walls. This will insulate the entire wall. If you insulate between the studs, t...
1
answers303
ViewsYes, Nail the hangers on with teco nails, then toe nail the joists with 12d nails thru the punch outs. This just saves the step of toenailing the ...
2
answers331
ViewsAsbestos may be a problem in "old" drywall, However it does not have the concentration that pipe insulation has. I would not be concerned unless y...
2
answers680
ViewsContact a local pest control company and have them come out and do an inspection, or contact a Home inspector and have them check out the house. A...
4
answers873
ViewsDrewb, Know your problem well, lived on the other side of the hills for awhile. Make sure that the power auger that you rent is not an old belt dr...
5
answers523
Views