Pressure Washer

Interested in purchasing a pressure washer. Uses: Washing my vinyl siding house 2-4 times a year (highest peak is about 30 feet), washing the dec...

over 7 years by dogger

0

answers

888

Views

fix

i did a better job of hooking up the black on black, and also hooked the 2 copper wires together, and it works..... only problem is the black wi...

over 7 years by dogger

11

answers

72

Views

wire

when i was disconnecting the original fixture, the copper wire from the wall was screwed down under a screw on the housing that's attached to the w...

over 7 years by dogger

11

answers

143

Views

elect. tape

do you think if that's the problem - the copper hitting the black, that if i put electrical tape around the copper wire then that would be ok? tha...

over 7 years by dogger

11

answers

618

Views

fixture

thanks, househelper. i'll give that a shot tonight, and see how it goes. i assume i won't be doing any damage, do you think?

over 7 years by dogger

11

answers

388

Views

gift car?

cricketb - i'm sorry, but i think your comment about a good follow-up being a gift card to say thanks to your neighbor for taking responsibility an...

over 7 years by dogger

4

answers

82

Views

Dead Trees

I live in the central virginia, and we haven't had much rain at all this summer, or really even since the spring....anyway, I have a new constructi...

over 7 years by dogger

0

answers

784

Views

fuse/breaker problem

I haven't tried to put the old fixture back up. I don't want to cause a 'bigger problem' than I already have, but it's a pretty simple connection,...

over 7 years by dogger

11

answers

383

Views

Fuse/Breaker Problem

Tonight I installed a new light fixture on my porch. I shut off the breaker switch and turned it back on when I was done connecting the wires. Tu...

over 7 years by Billhart

11

answers

943

Views

hooking 2 hoses to one spicket

Hi. I'm trying to get a dual sprinkler system going off of one of my spickets, but tonight when I hooked it up, and had both lines working at the s...

almost 8 years by dogger

0

answers

338

Views

thanks

Jim D- Thanks for the info. and the tips. I'll check it out. I'll also check out the forum you suggest. I guess it kinda begs the question to me...

almost 8 years by Jim D

1

answers

107

Views

solution....

i went up in the attic and tooled around a little bit, and found out that the 2X4 that the fan is rigged to was/is vibrating and thus causing the n...

almost 8 years by dogger

4

answers

786

Views

reply

i went up in the attic and tooled around a little bit, and found out that the 2X4 that the fan is rigged to was/is vibrating and thus causing the n...

almost 8 years by dogger

4

answers

203

Views

yes

yes, there are two vents. one is just in front of the fan, so it can push the air out. there is another vent on the other side/opposite end of th...

almost 8 years by dogger

4

answers

798

Views

attic fan problems

hi. I have a 1 year old home, and my gable fan (actually, it's attached to one of the walls of my home, flush against the wall, so not sure if that...

almost 8 years by Jim D

4

answers

689

Views