resolution
...been a while on this issue, but the resolution was to flip a 'dip switch' that disables the back-pressure sensing. The gas supply was not a prob...
COMMUNITY FORUM
Recent Posts
almost 7 years by dtbaker
8
answers941
Views
manifold adjustment
I found a Boech installation manual which states that manifold pressure should be reduced by 4% per 1000' of elevation, which means that I *should*...
over 8 years by dtbaker
8
answers850
Views
adjusting manifold pressure
the tk-jr is the smallest takagi unit (140000btu max), and the specs are for 3/4", so I think I'm fine with the gas with the runs I have according ...
over 8 years by dtbaker
8
answers541
Views
more info
the gas line from meter to house is 1", then there is a run of about 12' to the heater, most of it was 3/4", and the last bit sticking out the wall...
over 8 years by dtbaker
8
answers733
Views
problems with a takagi tankless
I just installed a takagi tk-jr tankless water heater. It serves the master bedroom and kitchen, so the size is just about perfect. I have had s...
8
answers667
Views
