I am finishing my stair trim in redoak and the 1x4's that hang down to accept the drop in ceiling are in oak also, I was going to buy 8 1x6's and c...
I am in the process of finishing my Basement and it's almost door installing time. I have to install a 30" door, a 36" door and a two 30" door set ...
I hope that I did the right thing. Originally I was going to drop my ceiling doem 4 and a half inch's to compensate for the 4"drains elbow. After l...
I want to box in my Jackposts and want to use Oak to do this. I am planning on using red oak to build my staircase banister and the fake oak moldin...
I am in the process of finishing my basement and Home theater. I just finished the drywall and am about to tackle the ceiling. I plan on using 2x4 ...
I too am installing home theater buy my walls are still roughed in. Do you have any specks as to where the wire should be run for the two fronts an...
I am in the process of building my family room in the basement. I want to install all the extras such as recessed lighting above my computer workst...
A good rule of thumb to cutting crown is Upside down and backwards. I have a power mitre and still rely on coping method. One thing you want to rem...
I want to install two electric baseboard heaters in my basement. I have already run 12-2 from my panel to the thermostat and 12-2 to a junction box...
I went back and took half of the receptacle circuit and put it on another breaker so I split them up
i just finished doing mine and had to use 2x4 for pipes but like you i didn't have much room at the bottom of steps. I put 2x4's on side and tapcon...
WE had this house built about ten years ago and the range came standard. Recently the temp. in the oven compartment hasn't been up to par. Is there...
I checked and as far as I know i can have a total of 4300 watts and using an eight footer and a six footer I will be well below that
I am running 14-2 wire to my new addidtion. I plan on hooking up about ten receptacles to this circuit. I am also going to jump from one recept. to...
I am in the process of doing my basement and want to install two electric baseboard heaters. I plan on running 12-2 from panel to stat and running ...