Washing Machine tub not spinning or draining
Dear Joel,You might not be able to see, but, if the machine will not spin, is the motor running? If it is your belt is either off or broken. If the...
Dear Joel,You might not be able to see, but, if the machine will not spin, is the motor running? If it is your belt is either off or broken. If the...
1
answers988
ViewsDear Zinch,You have to look into commercial applications. Grainger, McMaster-Carr, etc.It might be better to have a regular ceiling vent installed....
1
answers68
ViewsDear RNV,You might also ask your electrical provider to check the voltage coming into your home. Wher I live in Ga., I had this problem. It turned ...
2
answers980
ViewsDear Garret,If your faucet is of Delta manufacture, it may contain a ball inside that acts as the valve. If this is so, check to ensure that the pi...
2
answers752
ViewsDear Msburger,The best product I've used is Tung Oil, available at Home Depot. This stuff makes scratches disapear and is very easy to use. Just fo...
1
answers734
ViewsDear JC,You can find the insulation at any Home Depot, plumbing supply, heating suply, or most hardware stores. Ask for Armaflex rubber. The idiots...
5
answers613
ViewsDear Lightgirl,If I came to see the moose, it'd be steaks within the first hour. LOLLen
8
answers22
ViewsDoes anyone know a resource for plaster buttons in the Atlanta, Ga. area? I'm getting a little tired of making my own.
0
answers711
ViewsDear Lightgirl,In my experiences through the past 30 years, contractors will install the cheapest switches they can find. After the breaker blows o...
8
answers591
ViewsDear Wrkggrl,It as not as simple as you would think. If the texture paint is a sand base, use a 90 degree scraper to take off the texture, patch, p...
2
answers534
ViewsDear Titus,If you're refering to the melamine covered hardboard, try a little polishing compound to smooth out the scratch if it does not go below ...
1
answers857
ViewsDear Lincoln,I've seen this before. You have the flat part of the metal,"drainpan", and the round part of the metal,"crown". The screw always goes ...
2
answers714
ViewsDear Lost,Try using a coathanger to clean the holes under the rim of the bowl and then shut off the water and pour a bottle of CLR right down the f...
20
answers726
ViewsDear KYLLMAN,Try this site: http://www.marmoleum.com/welkom.html This is the manufacturers homepage. Personally, I do not care for any flooring of ...
2
answers267
ViewsDear Bug,I did some checking with our local EPA rep and he said that if you spray the suspect areas with a clear laquer, you would "encapsulate" th...
3
answers178
ViewsDear Bucky,First, what does the smell resemble? Sewer gas does not always smell like sewer gas. Check the traps under your basin and/or tub. If the...
8
answers121
ViewsDear Mauv,The finish is up to you. If you paint, prime the doors, both sides, top and bottom and paint. If you stain, lightly sand with 220 grit pa...
2
answers747
ViewsDear Jodi,The device you speak of is the tank drain spigot. If that is all that is leaking, you need to shut the gas off, drain the heater, remove ...
3
answers677
ViewsDear Mark,The reason your blowers are cold can be that you have air in the lines. If there is air in the lines, the bubbles will act almost as a cl...
6
answers944
ViewsDear Brooke,I've heard all the pros and cons of "tile" paint and have found out for myself that it simply does not hold up. It looks really ratty a...
1
answers903
Views