Insulation for cathedral ceiling
I haven't got the house built yet, but I am very interested in how to do this also. I can't find any refernce materials on this subject. Any hel...
COMMUNITY FORUM
Recent Posts
about 8 years by jfsmith
1
answers479
Views
Ceiling light ficture
I would take the fixture out, use twist locks on the wires and get a blank faceplate for the junction box. Keep the circuit and your home safe. ...
about 8 years by jfsmith
4
answers542
Views
Low Voltage Wiring
I would check with the zoning folks about the need to have this wiring in conduit. I have run, accent lighting wiring, intercomm wiring, speaker wi...
about 8 years by jfsmith
3
answers906
Views
CO Detectors
An elderly lady friend asked me about CO Detectors yesterday. I said that they are great to have, she said she moved hers from her old home to her ...
0
answers626
Views
GFI Failure
This sounds like a neighbor I had, her GFI would trip for no reason. Then I found out that her garage was down stream from her GFI. She had an elec...
about 8 years by jfsmith
10
answers843
Views
Not Sure
If your dimmer has short jumpers you can make those out small pieces of wire. I am not sure if that is what you are asking about, so I thought I wo...
about 8 years by jfsmith
2
answers1002
Views
Panel to Welder
Tom, I prefer to be 200% over spec than 1% under spec. Thanks, Jerry Jerry Smith Support Your Local Artists They Make Neat Stuff
about 8 years by jfsmith
2
answers643
Views
Power Feed from Panel to Welder
I need to run a 50 amp 240 single phase circut in my basement to a Arc Welder. I have many people tewll me to use 6-3AWG wire and only one place th...
about 8 years by jfsmith
2
answers394
Views
Generator Oulets
As to the diagram I have a link to, here is the wiring arrangement: A (NEMA L5-30R) 1--Neutral 2--Hot 3--Ground B (NEMA L14-30R) 1--Groun...
about 8 years by jfsmith
4
answers744
Views
Outlets on my Generator
I am in the states, namely Ohio and the Generator was made in Wisconsin. Jerry Jerry Smith Support Your Local Artists They Make Neat Stuff
about 8 years by jfsmith
4
answers162
Views
Outlets on my generator
I am going to be using a contractors type of generator for using some of my on site architectural metal work. This is work that I may do with a met...
about 8 years by jfsmith
4
answers250
Views
