If the plywood is solid then don't worry about the discoloration.
The house should be build to avoid frost heaving. There should not be "frostline cracks". You say it is not big enough for your pinky, but it must ...
Just remove the wire from the breaker and pull it out of the main panel. Your electrician brother in law should be able to do in 10 minutes or less...
Here's a tip that might help you. When you trim the curved edge, trim the rabet to a square shape. That way you can install a square piece of glass...
It sounds like your tank may be air bound. Turn off the pump and open a tap until all the water and air has stopped coming out. Turn on the pum again.
I once used a can of spray foam on the under side of a toilet to insulate it from the surrounding air for just the problem you are having.
Is this going to be a slab on grade porch or is it going to raised up the 27" to be level with the door or one step down?
Open the door and pull the release cord to close the door manually. Does the door open and close properly with ease when you do it manually? If not...
Check the instruction set for the dimmer and determine which wire is the common of the new dimmer. If I had to guess I would say the red wire on th...
opion from the limited amount of K&T I have seen. The 2 conductors are separated by several inches so there is little chance of a short even if the...
You will need to add more ires from the devices to the switches you want to install.
From 1946, the wire you have sounds like tinned copper. Treat it like any other copper wire. You don't have to wipe the silver coating off to use it.
I don't know about the poop but I have read that giving a table spoon of tomato juice a day to the dog will keep the urine from from burning the lawn.
You don't have enough wires between the lights to make it work. You can't do it the way it is wired.
I need some more info.Where does the power come in? Switch? light?Where do the wires run? From switch to light to switch? From switch to switch to ...