Option
I changed a couple of windows that were essentially doors but they did not open. You can also get a window slightly smaller than the width of the d...
I changed a couple of windows that were essentially doors but they did not open. You can also get a window slightly smaller than the width of the d...
3
answers591
ViewsWhy not just carpet the steps ? I am in the process of finishing mine and this is probably what I am going to do.
5
answers3
ViewsWhy not just fix them, it is pretty easy and cheap. on the side jambs there are inspection ports that need to be opened to get access to the weight...
1
answers135
ViewsI have a two story house with central Heat & air. I have dual zone (upstairs zone & a downstairs zone)with one unit. It works good but I rarely nee...
0
answers874
ViewsI am getting ready to install a brick patio and I am not sure which way would be the best to attach the brick pavers (1" thick) to the existing con...
0
answers631
ViewsIt is probably just coondensation that the heater either generates or removes from the house. My heater is up in the attic and I have a piece of pi...
2
answers771
ViewsI would remove the old frame to lessen the chance of aluminum attracting moisture. Removing the frame will also permit a bigger window (less frame)...
1
answers923
ViewsI installed two Atrium french doors that i got from Home Depot and I as well as some of my contractor friends have been very impressed with the ove...
1
answers321
ViewsAardvark, Your installer is probably just installing retrofit construction windows and is relying on the bead of caulk method. This is ok but I wou...
2
answers432
ViewsI believe if you have two seperate sets of vents, you should be doing the opposite. Hot air rises so therefore the lower (ground level) vents shoul...
3
answers497
ViewsIf you are going thru the expense of a new heating unit, why not make sure you get the right size unit and calculate all of the variables other tha...
1
answers373
ViewsIf it was approved by the city building dept, I would think that is good enough and I would let the inspector know that the City already approved i...
1
answers100
ViewsI am thinking of going this route when I finish my basement this spring. i do not want to nail to the concrete and possibly cause cracks or moistur...
2
answers247
ViewsAs a short term (easy) solution, you can spray some silicone lubricant on the edge between the two doors. This will ehlp it with less resistance an...
3
answers943
ViewsThe reason it does it towards the end of its cycle is because the heater unit shuts down at the end of its cycle but the blower usually runs for a ...
3
answers937
ViewsLots of variables.....material type (shake, asphalt, etc). Pitch (steepness plays a big part too. Tear off, quality of material etc.Basically need ...
1
answers705
ViewsMillguard are a nice window. I believe they are among the better vinyl windows out there. if the house is more of a traditional house, look into th...
1
answers150
ViewsYour humidity level is too high in your house/attic. You need better ventilation. Make sure you have and use exhaust fan in bathroom/kitchen. You a...
1
answers40
ViewsI have a Trane and have been very happy with it. It is about 6 years old and has a 10 year warranty. I hear Lennox is good too however it is very e...
2
answers396
ViewsHello everyone. I recently installed some Pella aluminum clad casement windows and they seem to stick when opening. I think they may be sticking to...
1
answers427
Views