The "dollar bill" trick
I had Milguard classic (with wide internal grids)windows installed in my old house and was happy with them. I believe the cost was about $6500 (win...
I had Milguard classic (with wide internal grids)windows installed in my old house and was happy with them. I believe the cost was about $6500 (win...
3
answers43
ViewsPretty much ! Look into just replacing the actual pane first not the whole unit !
2
answers435
ViewsThey may do this if they are not plumb and level !
2
answers622
ViewsI am actually having a hard time opening mine after they have been shut for awhile (few days). It is like the window is sticking to the rubber seal...
1
answers273
ViewsI have a two story (2200 sq') & I think a 4 ton AC unit. My upstairs would be hot (8-10 degrees warmer than downstairs) & the thermostat is downsta...
4
answers63
ViewsI recently had a similiar situation only with a squirrel. Probably not as bas a racoon though. My neighbor had the same situation only with a big o...
2
answers981
ViewsYou could try adding more ducts, another unit for upstairs, or do what I did with the same problem and add a duel zone damper.
2
answers192
ViewsBrick molding/stucco mold is about a dollar a foot. Very easy to put up after the door is installed. I recently installed two Atrium french doors (...
1
answers535
ViewsBasically that is what I am planning on doing HK. I was going to plug the new duct into the old one somewhere right before it goes into the registe...
1
answers583
ViewsI have recently had installed a duel zone split system in my two story house. The upstairs is one zone and downstairs is another. Everything works ...
1
answers483
ViewsWell then.............I guess you are just SOL !!
5
answers578
ViewsLook closely at the wood trim around the inside of the glass, it should pop out. It is probably being held in with either staples or small nails. l...
2
answers842
ViewsIf you can get to the other side of the wall (attic, basement, etc), you can slip the duct over the register flange and either duct tape it or use ...
5
answers101
ViewsI agree with Ldoyle, if I had to make a guess, I would first look at the roof vents to make sure they are not plugged.
4
answers243
ViewsYou may also want to check the coodes regarding outswing. I believe that there is supposed to be alanding/step that covers the whole swing of the d...
2
answers83
ViewsUsually a plumber will run or relocate your gas line.
1
answers646
ViewsThe seal is probably bad and it would probably be easier and maybe even cheaper to just replace the panes with new. Good Luck !
1
answers481
ViewsI believe that they are both made of wood with either vinyl or aluminum cladding so condensation should not be much of a problem. If their is exces...
1
answers245
ViewsThat is very high. I replaced windown in a house a couple of years ago with Millguard dbl hung loe2 and with grids. The cost was about 6000 for abo...
6
answers673
ViewsI am putting in some casement pella windows now. They install real easy however they come unprimed (inside) and are kind of a pain to paint. Lots o...
4
answers438
Views