Re: Loud vibrating sound from shower
Most likely the problem lies in the shower valve,might need washers,o ring,cartridge,ect.
Most likely the problem lies in the shower valve,might need washers,o ring,cartridge,ect.
7
answers151
ViewsDo you think maybe the pilot flame is too "intense" causing premature deterioration of the thermocouple. How could you tell?
8
answers695
ViewsSandpaper and appliance touch up paint depending on how bad it is, or you can buy just a new lid
3
answers796
ViewsThe only thing you're not supposed to do is have 2 wires under 1 screw terminal.The way you're going to do it is OK. The best way would be to conne...
3
answers358
ViewsSome devices plugged into GFCIs will cause nuisanse tripping such as refrigerators and other inductive loads.It's perfectly safe the way it was wir...
3
answers850
ViewsIf this is it it looks as if it's no longer available. At the moment anyway.http://sale.hsn.com/bob-vila-quick-change-utility-knife-with-55-blades...
5
answers509
ViewsThey make plastic spacers just for that. You can get them at home depot along with the longer screws. The reason I suggested taking the plate of...
4
answers117
ViewsTurn the power off then take the cover plate off. Now look and see what's not secure. Sometimes the receptical can just be tightened down in the...
4
answers893
ViewsI'm curious to see if this new thermocouple will last as long as the original one. Maybe they just "don't make'em like they used to".
8
answers933
ViewsI just replaced the thermocouple for the first time on my boiler about a week ago. I always leave it burning in the summer, just shut it off when ...
8
answers819
Viewsprobably a mole/s
6
answers409
ViewsI would lean toward a belt driven compressor as opposed to a direct drive. P.S. Every one I saw at the dewalt site was direct drive.I couldn't f...
1
answers419
Viewssometimes you can break the bond by actually tightening it first if not drill and/or cut it out.Then replace it.
5
answers869
ViewsI would not know if there is glycol in the system or not. Is there a way to check? In this particular case I would have a good heating company ...
3
answers684
ViewsIt is a closed system so it should be ok. However you are gambling on the fact that nothing is going to go wrong with the boiler.If it does good b...
3
answers35
Viewsthe web site is owwm http://www.owwm.com/photoindex/detail.aspx?id=11293
0
answers173
Viewsexcellent. You're hired.
7
answers499
Viewsexcellent. You're hired.
0
answers936
Viewsthey need to be the next size up for hardwood. In other words the holes are too small and not deep enough. simple as that.
5
answers470
Viewsthey need to be the next size up for hardwood. In other words the holes are too small and not deep enough. simple as that.
4
answers964
Views