bummer
sorry i couldn't help. maybe somebody else will be able to. good luck.
COMMUNITY FORUM
Recent Posts
almost 3 years by LarryG
3
answers599
Views
icemaker
that red led being on means the unit thinks the ice bin is full. if that helps. p.s. are you sure they are out of business. i googled franklin...
almost 3 years by LarryG
3
answers720
Views
yes but don't forget
something made it overheat.probably a lint build up somewhere,blocked ventilation.
almost 3 years by LarryG
9
answers746
Views
back of dryer
unplug dryer and there's a cover that you take off. http://www.repairclinic.com/SSPartDetail.aspx?PartID=2986 try to get someone to help you ...
almost 3 years by LarryG
9
answers729
Views
dryer (for now)
sometimes there is so much of a lint build up it restricts the airflow and blows out this little fuse in the back of the dryer because it gets too ...
almost 3 years by LarryG
9
answers4
Views
thanks Bob
thanks again Dan, i guess it was that unit just to the right of the fan. once i saw that picture you put up i realized that was it. thank you.
almost 3 years by LarryG
2
answers912
Views
refrig help needed
hi Bob, i have a maytag model MTB1954DR refrigerator. i took that panel off the back to clean the dust out,but i can't seem to see the actual co...
almost 3 years by LarryG
2
answers686
Views
water problem
this all started happening all at once ?
about 3 years by LarryG
2
answers130
Views
3 way circuit
basically the new light is going to be parallel with the existing light. i don't think the power originates at the switch because you said the e...
about 3 years by LarryG
1
answers960
Views
how i knew
a new stove doesn't come with a cord. if it had been brand new you would have looked at the receptical in the house and said: ok i need a 3 prong...
about 3 years by LarryG
4
answers421
Views
ok but not good
that new stove was used wasn't it. if you want it to be right you need to run new wire from the breaker box to the stove.
about 3 years by LarryG
4
answers360
Views
washer problem
this is a kenmore top load washer. 110 92580100 the trouble i am having is when you close the lid you need to push down on it to engage the l...
about 3 years by LarryG
2
answers933
Views
noise
if it's a single home most likely one of the toilet flappers is leaking causing the tank to keep asking for a refill. it this is an apartment bu...
about 3 years by LarryG
2
answers923
Views
didn't you say?
it only does it on the one side? try removing the aerator from the tip of the faucet and flush the lines out for a couple minutes and see if anyth...
about 3 years by LarryG
6
answers645
Views
drain
i think the noise is originating from the faucet and not the drain. doesn't the vanity share a common discharge pipe?
about 3 years by LarryG
6
answers653
Views
i doubt it
what happens is after time the flappers lose there softness and then they don't make a good seal.
about 3 years by LarryG
1
answers779
Views
spin flush
http://www.spinflush.com/ my 2 cents is no.
about 3 years by LarryG
2
answers35
Views
those were just guesses.
someone have to check it out to see what (if anything)is actually wrong.
about 3 years by LarryG
3
answers782
Views
