Hi Bob, i bought a used welder that requires a 50 amp circuit. what size wire do you recommend i use with a 50 amp double breaker?
that way you won't have to pay an electrican to tell you the problem's not in your house but in the outside line.
it sounds like to me that you have what is called a switch loop. the power enters at the fixture,then the hot is looped back through the switch. ...
open up some nearby wall switches and see if you can find the other end of the yellow wire,then note where it's connected to then post back.
you're confusing a receptor with a pan.a pan you tile over and a receptor(which can be cast iron by the way)already has a finish over it and is rea...
every duplex receptical has a snapoff tab across the hot screws that can be removed if you need to isolate one from the other for any reason.
there is such a thing as a "whole house surge protector." i don't know how rich you are though.
we were just guessing that someone replaced the recepticals and failed to note that the tab across the hots needed to be removed. i see it happen ...
i can't see any reason why a wall switch would be needed other than for convenience. the first one may have fried because you wired it for a load ...
you didn't say if it was new.and if you connected everything properly then just take it back.
"I bought the house and everything was new in the house" there you go.somebody "flipped"the house and goofed up the wiring.
what might help is fluidmaster makes a clorinating device that attaches to the refill tube and clorinates the water that goes into the bowl only.
pull the compressor disconnect and fire up the air.then turn on the radio. that would tell you if the compressor is actually generating the noise ...
the actual furnace,(not including the compressor)blower,relays,transformer,operate off 110.try plugging the radio into an outlet that is on the oth...
powering the radio off the other leg that the furnace is on for starters, then post back with results. is this something that always was or jus...