doesn't it need a seperate line to carry the water back to the heater. in other words a "loop"?
did anyone try a snake? also who made the diagnosis that it's frozen as opposed to just plain plugged up. in addition since you rent it is the lan...
the last time i had trouble like that what i did was unhooked the line from the faucet and found low water flow from the line. then i turned off t...
this is an indication of abnormally high temperature,pressure,or the valve has failed. call somebody.
any good bowl cleaner should work.remove the water and fill the an acidic cleaner and let it set overnight. even muratic acid be careful not to sp...
what about that screw?did you try taking that off? sometimes the only way is to cut.with a dremmell or a saw. it might help to remove the sink so...
for starters remove the aerator and turn it on and see if that helps. sometimes debris gets caught in there. post back.
if the faucet employs a common cartridge(in other words single handle),then i would try removing the cartridge,then turn on the water to flush ever...
it is possible the pipe is not secured to a point that the water is causing it to move around and hit against something.
if the tank keeps filling and the water goes down the overflow pipe then i would suspect a faulty fill valve.
the elements that were designed to be used with your tank are the right size.the only difference you will notice will be the tank taking longer to ...
forgot to mention the reset button. but if it's humming like you said,chances are the reset hasn't popped out.
depending on the brand it is some have a place underneath for a large allen wrench other types must be done from the top. most likely it's just st...
just solder the adapter onto the pipe,after it cools wrap the threads with teflon tape then hold the adapter with one wrench and tighten the valve ...
most likely the flapper is leaking very slightly.another thing that could cause that is the refill tube inserted in the overflow pipe below the wat...
most likely i would suspect the rubber washer that's under the tub drain or the overflow washer.or they could also be not tight enough.
for starters the correct way to snake a tub drain is through the overflow. as far as the tiptoe stopper goes try holding the stopper from turnin...