Re: Crack in Bathroom Sink
I would go with a 2 part epoxy as a temporary repair.
COMMUNITY FORUM
Recent Posts
11 months by LarryG
4
answers471
Views
Re: Mansfield toilet valve loud and fast
Usually what I do is replace everything in the tank. Since you have to remove it anyway to replace the flush valve. Bolts,fillvalve,flush valve,tan...
11 months by LarryG
2
answers835
Views
Re: Honeywell Cool Setting
Either way if it's set to the cooling mode cool air should be flowing if air conditioning is installed and working properly.
11 months by LarryG
1
answers17
Views
Securing Scaffolding to a House
I've used rope before around the scaffold out one window and into another.Just for security. Just make sure you level it out from the start.
11 months by LarryG
1
answers907
Views
Re: Installing a Pocket Door in a Thin Wall
2x4 minimum.
12 months by LarryG
2
answers798
Views
Re: roof venting
Usually you would want to go with a skylight (roof windows) in this type of situation due to the fact that when winter rolls around you want to clo...
12 months by LarryG
3
answers25
Views
Re: Only getting 12V at thermostat?
Doesn't the thermostat get it's power from batteries? If so it should display a reading even it it isn't connected. What is the model # of the new ...
12 months by LarryG
3
answers566
Views
Re: How can I remove
Suggestions: 1 use an easy out,2 just drill it out,3 If you have a dremmel you can cut a straight slot into it then use a screwdriver. That's abou...
12 months by LarryG
2
answers166
Views
Re: Only getting 12V at thermostat?
Was the system working correctly before you changed the thermostat. If not what was it doing or not doing.
12 months by LarryG
3
answers432
Views
Re: Genie Powermax 1500 Garge door opener problem!
Sounds like a spring or a cable broke.I suggest you don't monkey with it and get a pro for this one.
12 months by LarryG
1
answers677
Views
Re: 3-button wall switch doesn't work with new ceiling fan
Connect it back up the way you had it to begin with(brown to blue). It should work. There's no reason why it shouldn't after you set the pull chain...
12 months by LarryG
1
answers524
Views
Re: Unpaintable Caulk Used On Porch - Already Primed with Latex Kilz
Wait till it wears off then either recaulk with correct caulk or prime with correct(oil base)primer.
about 1 year by LarryG
1
answers899
Views
Re: Damaged Ipe?
Unless there are gouges in the wood from the pressure washer then there is no damage. It just needs to be resealed with a good quality sealer. Afte...
about 1 year by LarryG
5
answers397
Views
Re: Exterior door
Double check your measurements. I've never seen an exterior door that was 30".
about 1 year by LarryG
3
answers945
Views
Re: lights flickering in house
Without seeing it happening it's impossible to say exactly where the problem is, but it is a serious issue that needs to be addressed. There must b...
about 1 year by LarryG
2
answers34
Views
Re: Dents in Fridge?
Somtimes they can be pulled with a suction cup and somtimes they can be filled and painted like a car door.
about 1 year by LarryG
3
answers362
Views
Re: changing color of bathtub and tiles
The only way it's going to last is to replace the tub. A bathtub has a baked on finish that cannot be replicated outside of the factory.
about 1 year by LarryG
1
answers256
Views
Re: electric panel bus arc damage noticed in inspection
It makes you wonder what other surprizes there are that the inspector can't see. Nothing was said until he took that cover off right? Anyway bottom...
about 1 year by LarryG
3
answers702
Views
Re: A/C Unit - Bad contactor?
Could be: Wrong contactor for application,poor connection causing overheating,poor coil voltage causing it not pull in tightly,too frequent compres...
about 1 year by LarryG
2
answers828
Views
Re: Honeywell Thermostat
Yes it is possible. Not only that, if it had batteries and they were weak it would display lo batt or something.
about 1 year by LarryG
1
answers556
Views
