Re: Removing Aluminum Siding
I don't think there is a wrong way other than not to wear the proper safety gear such as gloves, safety glasses and particle mask.
COMMUNITY FORUM
Recent Posts
about 1 year by LarryG
1
answers248
Views
Re: Some good power tools to get started with?
At the very least a drill and a circular saw unless the shed is kit form, I don't think any power tools at all would be needed.
about 1 year by LarryG
3
answers660
Views
Re: Kitchen cabinet shelf
"The plastic pegs keep popping out." Put glue on them or wrap with a piece of tape to make them tighter?
about 1 year by LarryG
4
answers410
Views
Re: Hanging Door
The two sides have to come together flush in order for the door to close.
about 1 year by LarryG
5
answers150
Views
Re: low & high voltage to same device in junction box?
You need to switch in front of the transformer for the gas valve not downstream.
about 1 year by LarryG
1
answers142
Views
Re: Low Pressure in Shower
http://www.plumbingsupply.com/boostcitywaterpressure.html
about 1 year by LarryG
4
answers490
Views
Re: Energy Savers with Dimmers
Usually no. Unless the bulb specifically states that it can be used with a dimmer.It would say dimmable on the package. Even those lighted toggle s...
about 1 year by LarryG
6
answers414
Views
Re: Another question: Is all laminate equal?
Pretty much so.
about 1 year by LarryG
6
answers218
Views
Re: Weeds
Yes but it also kills everything around it so if you want to use vinegar apply it with a brush to the weed only,don't spray.
about 1 year by LarryG
3
answers519
Views
Re: RL Paint Absolutely sucks. Now I have to color match.
Without knowing exactly what happened I'd be inclined to lean toward operator error as opposed to material defects.
about 1 year by LarryG
3
answers797
Views
Re: getting rid of bathroom paint stains
Hot water and elbow grease.
over 1 year by LarryG
4
answers245
Views
Re: freezer making loud noise
The motor could be going bad.
over 1 year by LarryG
2
answers224
Views
Re: fixing crooked door
The hinge must be bent.
over 1 year by LarryG
2
answers137
Views
Re: non-muddable drywall?
You might try sealing the area first with shellac or a shellac based primer before you mud it up. I don't know what's going on but I do know they h...
over 1 year by LarryG
1
answers369
Views
Re: 2 new GE refrigerators and neither work
I mentioned I had a feeling it was getting stuck on defrost,maybe they had a bad run of control boards.Since it's still under warranty I would cont...
over 1 year by LarryG
3
answers334
Views
Re: Broil Element in oven - Kenmore 79096021400
Usually it is worthwile to replace an element if the rest of the unit is in decent condition.
over 1 year by LarryG
1
answers142
Views
Re: Odd electrical box
It's called a thermostat. Don't know what (if anything) it controls. From where I am I can only guess. Follow the wires connected to it and see whe...
over 1 year by LarryG
4
answers552
Views
Re: Odd electrical box
It's called a thermostat. Don't know what it controls. Maybe an exhaust fan or something like that.
over 1 year by LarryG
4
answers981
Views
Re: Hydronic boiler vent and pump flow direction
The pump should be pushing the returning water into the boiler.
over 1 year by LarryG
1
answers758
Views
Re: How do I do this test ?
Turn everything off in the house unplug everything then note the reading on the meter. Leave the breakers on. Then go shopping or something for sev...
over 1 year by LarryG
1
answers881
Views
