Re: outlet has diminished power
Have you checked the neutral where it connects at the panel? That's the only other thing other than a connection in a junction box. It may be a ded...
Have you checked the neutral where it connects at the panel? That's the only other thing other than a connection in a junction box. It may be a ded...
6
answers203
ViewsWhat does "blew" mean and why did you have to change the outlet? Is this a dedicated circuit for the microwave or a branch.
6
answers356
ViewsYou mean RG6 coax cable?
2
answers547
Views1. I would never rip out copper to put in pex. 2. The thing to remember about home run plumbing is at every faucet that runs back to that manifo...
4
answers118
ViewsHow long ago? I think it just needs to fully cure.
7
answers947
ViewsIt would take a long time but if all the water evaporated out of the bowl then sewer gasses would be emitted into the room from the toilet.
4
answers418
ViewsHappy New Year Sylvan! Sorry haven't been myself lately. I had to have my dog put down on the 13th of Dec. Getting back in the groove though. Hope ...
3
answers666
ViewsAnother thing I thought of was when they build the countertops was instead of using that cheap pressed wood insist on good plywood or even marine g...
5
answers214
ViewsYes,1. what needs to be done is the raw edges of the counter and backsplash need to be treated with sonething like paint or a good water seal that ...
5
answers519
ViewsIt would make more sense to try to attack the root of the problem if at all possible. Remove the source of the humidity in a natural way before it ...
2
answers700
ViewsEither way would work. As long as the socket is the conventional type with the screws that tighten down on the wires as opposed to something that i...
1
answers657
ViewsI would use a circular saw but don't forget you are going to need to set the bevel if the legs of the table are tapered.
5
answers167
ViewsTake the door off, bring it in and paint then put it back up. Otherwise wait.
5
answers893
ViewsI would say the washer isn't right or you left the old one still in there. You shouldn't need pliers to get it off or on if it's right in the first...
7
answers735
ViewsIt has to do with the rubber washer on the aerator. The old one was still in the faucet, or you simply didn't make it tight enough. Check it out.
7
answers281
ViewsWait for Bob's answer but basically what you're going to do is extend the wire from the outlet,keeping the white(neutral)intact to the new light's ...
3
answers960
ViewsThe first thing I would try would be to remove the aerator on the tip of faucet then open the faucet. If you then get good flow you can be assured ...
7
answers461
ViewsHI. Yes you need to cap off the black from the ceiling (which is constant) and connect the light to the blue (which is controlled by the switch). M...
2
answers490
ViewsThere is a hose that carries the defrost water from the freezer to the drain pan. Most likely that hose is plugged somewhere.
4
answers779
ViewsSounds good.
5
answers292
Views