Connect it back up the way you had it to begin with(brown to blue). It should work. There's no reason why it shouldn't after you set the pull chain...
Wait till it wears off then either recaulk with correct caulk or prime with correct(oil base)primer.
Unless there are gouges in the wood from the pressure washer then there is no damage. It just needs to be resealed with a good quality sealer. Afte...
Without seeing it happening it's impossible to say exactly where the problem is, but it is a serious issue that needs to be addressed. There must b...
Somtimes they can be pulled with a suction cup and somtimes they can be filled and painted like a car door.
It makes you wonder what other surprizes there are that the inspector can't see. Nothing was said until he took that cover off right? Anyway bottom...
Could be: Wrong contactor for application,poor connection causing overheating,poor coil voltage causing it not pull in tightly,too frequent compres...
I don't think there is a wrong way other than not to wear the proper safety gear such as gloves, safety glasses and particle mask.
At the very least a drill and a circular saw unless the shed is kit form, I don't think any power tools at all would be needed.
"The plastic pegs keep popping out." Put glue on them or wrap with a piece of tape to make them tighter?
You need to switch in front of the transformer for the gas valve not downstream.
Usually no. Unless the bulb specifically states that it can be used with a dimmer.It would say dimmable on the package. Even those lighted toggle s...
Yes but it also kills everything around it so if you want to use vinegar apply it with a brush to the weed only,don't spray.
Without knowing exactly what happened I'd be inclined to lean toward operator error as opposed to material defects.