Re: Is renters insurance worth it?
I always had it when we rented. The answer to what it actually covers (and what it doesn't cover) would be in the wording of the policy. You have t...
I always had it when we rented. The answer to what it actually covers (and what it doesn't cover) would be in the wording of the policy. You have t...
2
answers550
ViewsYes if only a certain area got exposed to say like water dripping on it or flame rollback ect.
2
answers521
ViewsYes I have seen them before. I always thought they were just felt. Never thought they were asbestos. I have to say I do not know for sure. Although...
2
answers803
ViewsIf it were me at this point I would remove the whole thing and take it to a plumbing shop.(not home depot or lowes)and have them refurbish it. It l...
2
answers754
ViewsThe part came in today.I installed it and it seems to be working properly now. I quess dishwashers are easy to fix just like everything else.Thanks...
2
answers541
ViewsUpdate: I found a check valve that was basically rotted away. I ordered a new one to install.I hope that's it.I'll know for sure when it comes in a...
2
answers505
ViewsHi I have a dishwasher that doesn't want to pump the water out. Before at the end of a cycle-- wash,rinse,ect you would hear a pump come on now you...
2
answers1099
ViewsAny water infiltration through the basement walls should be corrected from the outside of the building or you're just going to create more damage.
2
answers989
ViewsFirst test for a tripped gfci. If not then what you do is turn off the breaker for that circuit and open each box for that circuit and check for wi...
2
answers383
ViewsThere are plenty of those pre screened contractor deals here in the U.S. One I know of is hireitdone.com.
13
answers359
Views"No, that 400 is only for the labor i have to supply everything else" Then I think it's a "ripoff" I would get some more estimates.
13
answers477
ViewsUnfortunatly that's about right,actually it's a pretty good price if he's going to furnish the door and all the materials to install it, going by w...
13
answers982
ViewsIf this is a line voltage setup then you can't use that thermostat. It will fry on the spot. If you only have 2 wires going to the thermostat they ...
2
answers792
ViewsBy rights the wire should have either been replaced or an accessible box installed at that point. Nobody is going to tell you otherwise. What you d...
3
answers597
ViewsNot turning fast enough?
2
answers767
ViewsCheck for voltage coming out of the transformer first thing. It sounds like you lost power to the front of the transformer usually if the button or...
5
answers673
ViewsThe wrong kind of caulk was used. Remove it, clean area with denatured alcohol or acetone and redo it using 100% pure silicone caulk and wait at le...
1
answers777
ViewsAs long as you haven't lost pressure in that zone for whatever reason try this. Totally saturate the head (everything that moves)with silicone spra...
1
answers141
ViewsYes depending on how bad you let them get. Sand off the rust and treat with a rust reformer and then paint.Repair any through holes with fiberglass...
7
answers666
ViewsYou need to know which cable is the power feed and which cable runs to the switch. As far as the light fixture is concerned the 2 blacks and the 2 ...
2
answers595
Views