Wood finishing
I have panelled my basement in knotty pine and plan to polyurethane. At what point should I fill the countersunk nail holes with putty? In between ...
COMMUNITY FORUM
Recent Posts
over 12 years by BobF
2
answers1026
Views
Primer
Is there a exterior primer that is effective below 50 deg?
over 12 years by ICHandywoman
2
answers353
Views
Deck Treatment
I am presently having a mahogany deck built. Any advice on deck stain or treatment?
over 12 years by lrodptl
0
answers300
Views
solar tubes
Does anyone know the manufacturers name that produces solar tube inside lighting? Not to be confused with solatube.
over 12 years by lrodptl
0
answers479
Views
replacing steel basement windows
My basement windows are set in the concrete foundation. Can I get a step by step for replacing with vinyl? Thanks
almost 14 years by lrodptl
0
answers257
Views
2 prong-3 prong conversion
I recently changed 4 outlets from 2 prong to three prong. There was a neutral, hot and bare wire ground. Should this be a problem assuming the wire...
about 13 years by rpxlpx
1
answers441
Views
Pergo Floor
I have a pergo floor and it is an unforgiving floor. The company who installed it, which has an outstanding and long reputation, has discontinued s...
over 13 years by lrodptl
3
answers964
Views
Tiling Concrete
I am planning to tile my 3 season porch which has a concrete floor. This floor has a rough texture and I have concern over tiling directly on it. A...
over 13 years by lrodptl
0
answers903
Views
Hoildays
I just finished my basement in Pine shiplap. Because the wood was so warped and twisted I had to use more nails than I would have liked. I have cou...
over 13 years by MONTANA
1
answers1034
Views
Pine Shiplap Panelling
I'm installing pine shiplap panelling in my basement vertically. Right now it is a cool and dry space. Should I be butting these panels up against ...
over 13 years by jh
1
answers960
Views
Finish Nailers
When installing tongue and groove pine board and it is necessary to pre drill the nail holes in the tongues, could this step be skipped if using a ...
over 13 years by lrodptl
0
answers514
Views
Tongue and Groove vs. Shiplap
For panelling a basement, is one of these panels better than the other? I was told by one person at Home Depot that shiplap is more prone to warpin...
over 13 years by jh
1
answers815
Views
Tongue and Groove paneling
Could someone give me the basics on tongue and groove paneling installation? 1x6x8 pine board. Thanks[This message has been edited by Handyman (edi...
over 13 years by Handyman
1
answers126
Views
