Need Floor Tile to Shine
The shiney areas of the floor still had finish on it and the dull areas are more the way two coats over bare tile should look.The only way around t...
The shiney areas of the floor still had finish on it and the dull areas are more the way two coats over bare tile should look.The only way around t...
1
answers448
ViewsI would question the builder as to how this was installed followed by warranty information on the vinyl product.I'm guessing that either there was ...
7
answers657
ViewsAppliance spray paint is available at most hardware/home improvement stores.If I were attempting this,I would remove the doors and door hardware(or...
1
answers393
ViewsThere may be "special" finishes for marble,however,I have used several coats of regular floor finish in the past with good results.Remember that an...
2
answers560
ViewsThis sounds as thogh it would be a pretty complex engineering situation beyond most of the participants in this forum.If you don,t hear from anyone...
1
answers252
ViewsYou may find someone here who has one,if not,these units are designed to supply on demand.I know Aquastar has a web site(www.cetsolar.com),others p...
1
answers697
ViewsThere is alot to be said on this subject and I can only offer some personal opinions.I don't think there is anything more important than using pers...
1
answers836
ViewsWhile silicone based caulk is very common there are others such as asphalt based,Nitrile,Neoprene,polybutane,rubber,etc.To be sure,I would consider...
3
answers335
ViewsDryer vents normally are not in excess of about eight feet and terminate through a wall to the outside.There,a standard dryer vent with cover is in...
3
answers148
ViewsThe response I got from a bricklayer was that moisture is pushing salts/minerals out of the brick and/or morter.I believe that there is some concer...
2
answers612
ViewsI have used various adhesives in the past and have found contact cement to hold up the best.Follow directions by applying cement to each surface an...
2
answers834
ViewsIf you get no responses on this and you don't find what you want,get a paintable caulk and paint the surface.I painted caulk by accident once and t...
2
answers661
ViewsScrape surface residue off as best you can,then follow up by wiping with mineral spirits.Continue until the cloth no longer picks-up soil.If the te...
2
answers976
ViewsAfter trying numerous things myself,I was about to give up.I took a wild guess that my walls needed venting.On the exterior of the house I installe...
1
answers805
ViewsLooking through plumbing supply books I found tub drains which screw down into the tub drain pipe.If you look down the tub drain and can see thread...
5
answers434
ViewsI looked into this a little further and was going to tell you that the new pedestal probably wouldn't fit because the original didn't either.A vani...
4
answers471
ViewsI have seen the posts but have never seen nor had to repair such a problem.Possibly someone else will help out or request more information.
5
answers214
ViewsProperly installed quality plumbing fixtures don't fall over.To avoid a problem with the landlord you can probably replace it relatively cheap.Requ...
4
answers809
ViewsConsider that anything you do short of removal still is a threat should there be impact or water damage to the ceiling in the future.Doing research...
2
answers944
ViewsI would use liquid nails available at home improvement stores and probably caulk where the stainless steel butts up to adjoining surfaces.You can u...
1
answers34
Views