We too ran into the same issue. One thing to keep in mine is the bottom of the window may determine if have to have tempered glass. In our area i...
I am going to install trench type floor drains in my pole barn before my concrete guy starts. How much pitch of the floor should I allow for the d...
I need to correct myself, if a twinning kit is not installed you will push and pull air through a unit that is not pushing air. You do not want th...
If they are not twinned properly with a factory twinning kit, they will do exactly as you have described. They are not to common but they are out ...
If you live in a climate with very cold winters, I would say get a humidifier. With normal house leakage aside, cold air cannot hold as much moist...
There are a couple of manufacturers out there and we use a lot of the Honeywell and Stargate systems. Here is a link to help. http://www.smarth...
I have seen flyers from companies whom sell outbuilding systems that they will deliver to you and you assemble them. Does anyone have any experien...
The item on the elbow may be a 'spill' switch. What is the exact model and serial number of your unit?
The two item with the red buttons in the middle are the roll out switches. The other item on the elbow is confusing me. Let me see if I can get a...
Never mind, I see that you are hooking a new board up to existing components. From your previous post, you mention a device with upper and lower s...
Well, your half way there. It is possible that you may have a comination high limit/fan control. Is there a part number on you new limit?
The rollout switch sense flame rollout. It is typically a small disc shaped sensor that is located near the burner assembly. The high limit is us...