power wash house

Hi, I have a ceder shake house with trim on the corners, eaves, soffits, windows etc. it is flaking and down to bare wood in some places. I was t...

almost 9 years by 5slb6

1

answers

318

Views

sub panel

Hi, I am going to run a sub panel to my detached garage undergrond in plastic conduit. It will be a 50 amp subpanel, I was told I could use alum w...

almost 9 years by bcelect

1

answers

1008

Views

fixing concrete

Hi, I have a detached garage that I am insulating and heating the concrete floor is in need of repair it is chiped and pitted the areas that need ...

almost 9 years by moby96

0

answers

807

Views

Thanks, I guess.

M

almost 9 years by moby96

17

answers

309

Views

REG

I am pretty sure it is the correct unit it is the idenical model as the one that was in the house (Watts U5 Rated 300pds max with a range of 25-75p...

almost 9 years by moby96

17

answers

319

Views

?

The new presure reg IS set @ 50pds I have not fiddled with it. It stays 50-52pds until at some point in the night when it jumps to 100pds, the cit...

almost 9 years by moby96

17

answers

295

Views

insulating

I have a detached garage built in the 50's that i am going to use as a workshop. It has a concrete floor 2x4 walls and I am insulating it with pape...

almost 9 years by tomh

1

answers

752

Views

replaced.

So I replaced the presure reducer and it seemed to help a little the presure peaks at 100pds instead of 140pds. I will install an expansion tank th...

almost 9 years by moby96

17

answers

931

Views

pressure

There is pres reduc valve installed before the meter. Since i am getting readings of 140pds is it defective and should i replace it? and the expans...

about 9 years by moby96

17

answers

291

Views

Pressure!

So I checked the pressure (left the gauge on all night) it was around 60pds all day and at the boiler it was 20pds. This morning I went down to che...

about 9 years by moby96

17

answers

232

Views

some more info

So today, I will go pick up a pressure gauge to test the water pressure. There is a pressure gauge on the boiler and it reads around 20p it maintai...

about 9 years by moby96

17

answers

406

Views