3 wire
Using your question, of a 14-3 on the same phase, the short answer is it would seriously overload the neutral. Worst case would be 15 amps on each ...
COMMUNITY FORUM
motor-T
Member since 09/27/02Recent Posts
over 10 years by motor-T
3
answers282
Views
Electrical Dryer outlet
On the newer Dryers there is a bonding jumper that must be removed in order to isolate the Neutral and to properly install the Equipment Grounding(...
over 10 years by motor-T
3
answers77
Views
Satellite Grounding
Scott-you do not want to run the messenger to its own ground rod. All systems coming into a residence should be grounded to a common point.(this me...
over 10 years by motor-T
7
answers953
Views
2 circuits with 20 amp 2-pole breaker w/GFI's
To my way of thinking, its cheaper and easier to install a 2-pole 20 amp GFCI breaker the cost what about 60 dollars as compared to the cost of the...
over 10 years by motor-T
2
answers56
Views
Knob & Tube...circa 1924
The ceiling will have to be cut into to refeed the fixtures. The problem with knob and tube is you can have one wire coming in from one direction a...
over 10 years by motor-T
3
answers330
Views
Any opinions or experience with Power Planner?
Never seen on of those, the ones I have installed are the whole house deals. They come complete with a power monitor and feedback from two CTs. The...
over 10 years by motor-T
2
answers696
Views
Dryer trips Breaker.
This sounds like a Siemens double-double pole breaker they take up only two spaces instead of 4. The problem is when one fails you got to replace t...
over 10 years by motor-T
5
answers616
Views
Wiring a compressor to a generator
EI Its not fuzzy math, the 240 volt output is rated at 5kw, there is also a 20 amp 120 volt receptacle included with these units, hence the 41 amps...
over 10 years by motor-T
2
answers316
Views
