hi, i currently have oak floors going down my hallway..i want to change it to tile....my questio is, can i tile over the hardwood or do i have to r...
Hi, i am planning a bathroom remodel in which i will be relocating the tub,toilet and sink. I was told that if i position the toilet ****hest from ...
I am preparing for a bathroom remodel and need help!!! the drain for the tub ,toilet and sink is all old cast iron. how do i connect new ABS drain...
hi, can anyone one give me any advice with gas pipes? my gas pipes branch off to the laundry room after they go to the furnace..the previous owner ...
thanks for the advice guys, i think once spring gets i here i will have someone cum out and have a look at it...
why not just hard wire the the lights with 14/2 in the wall and connect to your switch..?
a licensed electrician once told me that a 15 amp breaker can handle a max of 12 outlets or 12 lights (max 100 watt each light)..
can any one give me any info on the cost and types of repairs for a driveway?? my driveway has cracks and also tire ruts formed in it, which causes...
the plastic under the dirt was most likely put there as a weed barrier...by putting this plastic down weeds can't penetrate through and make the ya...
hi, thanks for the info ..... does anyone think they could tell by looking at pictures of the floor?i have pics and can email them to someone if th...
hi , i have wood flooring in my home , the boards measure 1 1/2" wide x 1/2"-3/4" thick, and they run in various lengths..but they seem fairly long...
You say no big deal, just cut out the drywall and replace with a new piece if a pipe were to leak...well actually it's kind of a pain in the ass..f...
i recently had a similar problem..i purchased this stuf called "goop", but there's 2 kinds ,make sure you get the one that says "plumbing".. it app...
i would recomend using the steamer for the most part and try to get all the wall paper off.once the majority of it is off take a palm sander with a...
I got sucked into the ads on tv for the rotozip and bought one about 2 years ago...i think its the worse tool i ever bought....DO NOT buy one..the ...
yes there is a way....ist you have to start with a small drill bit and work your way up to the size hole you want..second you can't drill to close ...
there's a couple of ways to build an ice rink..ist you can just shovel out a section for the rink to be and use the snow to make banks, which will ...
no problem !!! if you already have cable tv and cable internet all you have to do is make sure that the filter going to the internet stays with tha...