front steps
I just had my front steps replaced using granite slabs. Becuase the granite used did not come in the size I needed ( 11 feet), the mason used two ...
COMMUNITY FORUM
Recent Posts
almost 4 years by chaseblades
1
answers851
Views3
answers58
Views
refrigarator sound
I have a 20 year old refrigarator in the basement that seems to work fine The problem is lately is that it emit a fairly high pitch sound most o...
over 4 years by DanO
3
answers223
Views
green substance in bathtub
I looked at a bath tub/shower in our guest room. We do not use bath often. Under the tub faucet and under the shower head was a dry green subst...
0
answers629
Views
i need moore help
I still can get the closet lights . I correct the problem of the closet switch opening the main lights. Any idea how to fix this thanks
about 5 years by ramsey76
3
answers770
Views
thanks - wrong
Tim Thanks so much for your help. Before going to work I changed the wire from the lower side screw to the upper side screw and I managed to g...
about 5 years by ramsey76
3
answers268
Views
simple switch replacement gone wrong
I have a light fixture in a walk in bedroom closet that does not work. I check the light blubs and they are fine. I assumed I had a bad switch. ...
about 5 years by ramsey76
3
answers415
Views
KWC faucet
I have a problema with a KWC kitchen faucet. It a signle lever model and it about 17 years old. It think the model name is Luna. The problem i...
0
answers720
Views
central air
thanks I live in 5000 square foot colonial
over 5 years by ramsey76
1
answers345
Views
central air question
MY central air systems had problems this year delivering cold air beddrrons on the second floor. I have a large colonial with two sytems ( 5 tons ...
1
answers998
Views
GDO
Make sure the GFCI on the circuit was not tripped and need to be reset.
over 5 years by ramsey76
4
answers357
Views
phone
I agree that the old network interface should been removed years ago. You should call AT&T to install a modern inteface. there should be no charg...
over 5 years by ramsey76
5
answers337
Views
jack
this is hard problem to fix via a message board. Did you ever have dial tone in the trouble jack. Open the jack and see if there are any loose ...
over 5 years by ramsey76
1
answers360
Views
dimmer
Thanks for the help. I started from scrath this morning and got the dimmer to work. I was confused when I saw two light switches sharing a feed...
over 5 years by ramsey76
5
answers202
Views
dimmer
Thanks for the help My problem is that I could not turn on light being controlled by a dimmer switch. That was the only problem area in the hou...
over 5 years by ramsey76
5
answers194
Views
dimmer switch
I had a dimmer switch that would not turn the lights on. I assumed the switch was bad. I purchased a new one and replaced. It seemed simple to m...
over 5 years by ramsey76
5
answers1016
Views
reply
Dan Thanks for the input. I got a few informal estimates from a few of my friends to fix. My view is that for approximately $ 300 incremenatal...
almost 6 years by ramsey76
6
answers588
Views
update
We have decided to get a new dishwasher. Everyday for the last week I push the start botton on the old ( current) DW to see if it will start. L...
almost 6 years by ramsey76
6
answers218
Views
maytag dishwasher problem- does not start
My 6 year old maytag dishwasher will not start. The model number is mdb9100aww. It work last week before we went on vaction. Today upon retu...
almost 6 years by MistressEll
6
answers1520
Views
