So I re-read the suggestions and see that I shouldn't use a single pole switch.But I can use a 3-way but can't dim from that location.
Wow,I had no idea that you are supposed to use a single pole switch at the other end.I've only installed the Lutron Smart switches as you mentioned...
I am finishing a basement and have just wired three sets of 3-way dimmer switches.Each set of two controls an area.While I can turn the lights on a...
Hi patchen, Everythihg you mention is important to do the job right and to make sure you don't have to it over.The reason coarse sand is required i...
tbone20tnt, I've found that filling the space with steelwool and then sealing the opening has worked well.
signal, Now I have to agree with the other posters. After reading their posts and looking more closely at your picture then at my house your builde...
signal,I just had my house built this year also and it had some pretty extensive flashing needed.I was'nt quite sure what you meant but I finally s...
atticwoes, here in Dupage County in Northern IL. there are minimal requirements if you have pulldown stairs installed. I too have a custom house wi...
Dan,I'm trying to find something that is made for your purpose.That's just the way I am.I hate to jerryrig things.No offense to anyone.Try a search...
dkap, Check out the "horizontal cable management unit" at this site, swdp.com.
dkap, Try "structured wiring" in your search. Also, try www.smarthome.com or www.homecontrols.com.
coairman,I'm backing Dave 100% on this.That is a load of crap that your builder is giving you.I just had my house built and have been in it for ten...
Hey Coairman,Daves advice is all correct. I am not an expert either but I have had two houses built.I had to chime in because I can't understand wh...
Still have to disagree with Dougs reply. If you have'nt signed anything that money is yours. If you did sign and he has'nt applied for permits he s...
Hi Sayde, Since you haven't received a response I'll give what I would do.If you haven't signed a contract you can back out and have all money retu...
tate16t,LDoyle is right adout his answers.What I can add is that 6.8 is O.K. but you can do much better.I am refinancing right now at a rate of 6.3...
cehceh,9-volt is pretty much the bottom end of drills.Even fully charged you will find it difficult to drill in the manner you are trying to.I have...
eak,Just remember that you can do whatever you want.My suggestion is;paint the woodwork white,the door white and the spindles white.Leave the rail ...
cehceh,No you can't leave it like this.First,you need to find out why the screws are sticking up.Could it be you are using a drill that is not char...
tmork,See, this is what I mean by not receiving any help.All they do is throw more questions at you rather then help with your situation.So, here i...