Paint and Gas Hot Water Heater
What MR.Paint said is true,latex will not and cannot ignite.If you using oil based yes shut it down to be on the safe side.
What MR.Paint said is true,latex will not and cannot ignite.If you using oil based yes shut it down to be on the safe side.
3
answers977
ViewsWhen you store the paint it only has a certain amount of pot life.Depending on quality of paint.If your paint is chunky when you go to use it,bring...
4
answers367
ViewsLacqueor Thinner,not paint thinner or mineral spirits they do not get aggresive enough to loosen up stain.Unless it is an latex stain (water based)...
1
answers987
ViewsTry Lo-wells,H-irshfields,S-herwin Williams,M-enards, if I don't space the words Villa's web board is very biased and will blot out the other store...
7
answers851
ViewsI totally agree #5 but let's just hope he Contractor,builder)can or does hire someone who can truly do a great job otherwise this person is just go...
5
answers452
ViewsNever tought of that,but just maybe they can lighten it just enough to her liking,that is my experience too that they can eyeball a color better th...
7
answers918
ViewsWell if auto body primer and paint won't work on metal we all better get fiberglass cars.Easily ready and appliable with aircompressor and spray gu...
11
answers15
ViewsGoof off should work
3
answers974
ViewsA better thing to do is go to a paint store and have them fix it the correct way and have them write the formula on the paint can you have this way...
7
answers660
ViewsWell usually people pay more for having this (though you wanted flat walls) now you have alot more you can do with such as sponge painting it or ra...
5
answers515
Viewshe said was looking for the best way to keep from happening again,so being that automotive paint (or industrial) and primer is what they spray most...
11
answers972
ViewsI would go to most any autobody store and get a good metal to metal primer they use on auto's,and use the same paint you would for a car.This would...
11
answers818
Views6
answers738
ViewsI have seen where people have put up a nice oak board that has a router (spelling?) or some kind of design on it,up one side of the wall to seperat...
2
answers588
ViewsThere is a drain plug,don't JUST drain the gas out,yes do this by removing the oil drain plug most likely located under neath the deck (where the b...
6
answers595
ViewsI used dura-lube on mine and lasted quite awhile.Like 6 months before squeeked again.
2
answers118
Viewsmake sure to use a solid decking stain not just any stain,it won't last as long.
10
answers394
ViewsScrews could cause decking to split,but like mentioned if predrill then would be ok,the nails if they use galvanized decking nails,there should be ...
2
answers596
ViewsSounds to me like a fuel problem,my push mower did this and what happening to mine was the primer valve would get sucked in and was getting to much...
1
answers253
ViewsI have been a owner of a painting business for awhile,and I would sand them with a 120 grit sandpaper,nothing major you are not trying to take it o...
1
answers69
Views